Electronics Forum | Thu Apr 07 14:11:33 EDT 2022 | SMTA-69080803
@Stephen How big was the adapter board? It's challenging to depanelize and tedious to manually put these tiny assemblies in a tray.
Electronics Forum | Thu Feb 26 12:06:59 EST 2004 | jimih280
I need a tape and reel vendor for 5mm through hole LEDs. Any recommendations and what do they charge?
Electronics Forum | Thu Mar 31 15:53:23 EDT 2022 | stephendo
And pin outs of both. Once I saw a SOT-6 replaced with a miniSOT-6 (IIRC) The pin outs of the two parts were different. We did make an adaptor board and it wasn't too bad. We populated a panel of the adaptor boards, depanelized them and put them in t
Electronics Forum | Wed May 07 10:15:46 EDT 2008 | llaerum
We are also having some issues with certain small parts. In our case this is tantalum caps and 0402 caps. We had a vendor admit after much discussion that the plating used from a particular orgin was different on the tantalums. The tehory is thatthsi
Electronics Forum | Wed Mar 10 11:46:07 EST 2004 | Bill Aldeen
In my earlier message, I wrote my email address wrong. It is baldeen@nuway.net
Electronics Forum | Thu Apr 07 20:42:19 EDT 2022 | stephendo
The boards were just a little larger than a SOT8. IIRC we had a pizza slicer type depanelizer and it wasn't too bad. We just did enough to populate the bare PCBs we had. Where I am now a customer has us put a QFP and a few other parts on a SOW28 f
Electronics Forum | Fri Feb 27 10:00:59 EST 2004 | pjc
www.argosyinc.com/tapereel_new.html http://www.electro-comp.com/ http://www.vtekusa.com/viptaping.htm http://www.vestalelectronics.com/ http://www.reelservice.com/ http://www.matr.com/
Electronics Forum | Thu Mar 11 11:49:22 EST 2004 | caldon
www.ox3.com has a great web site. 1) they have a pdf that you can use for $ or 2) they have an online glossary with parts and cost available. Cal
Electronics Forum | Mon Mar 22 13:07:25 EST 2004 | Richard Y
Try these guys out: http://www.cornetttapingproducts.com/ Tell the owner Chuck I reffered you. He's a great guy and is very reasonable. He even gives me hours in turn times AND that's making the tape and T&R the parts!
Electronics Forum | Mon Nov 12 07:58:55 EST 2007 | ksrsr
George, Who do you purchase your wave pallets from. Our vendors has not perfected this attachment yet and I need to get a source. Thanks, KSRSR