Electronics Forum | Tue Feb 25 17:46:35 EST 2003 | davef
And the really sad part about that is: Some organizations actually REQUIRED a institutionally myopic organization like the FDA to go "Hello, design has a BIG impact on quality and you HAVE to pay more attention to that area".
Electronics Forum | Tue Mar 11 09:33:06 EST 2003 | davef
I'm wrong about the MPM AP. I got my model designation crossed-up and was thinking of an older unit. I apologize to MPM for for my unfair criticism of their product.
Electronics Forum | Sat Mar 22 12:18:39 EST 2003 | MA/NY DDave
Hi, As I read and reread, I don't understand your question. Is it a design protection for in use?? Is it packaging while shipping protection?? What is the signifance of the 3Volts?? YiEng, MA/NY DDave
Electronics Forum | Tue Mar 18 09:09:37 EST 2003 | pjc
The FGLV has a air pressure displacement valve, which is designed for adhesives. A positive displacement valve is better suited for solder pastes. Check with Fuji to see if they offer optional valves.
Electronics Forum | Wed Mar 26 16:05:13 EST 2003 | davef
Ren�: Look here to get started with you efforts: http://developer.intel.com/design/Quality/component/rework.htm
Electronics Forum | Thu Mar 27 11:49:18 EST 2003 | kenlchin
In printing,the thickness of solder paste perpendicular to the Squegge direction is always lower 1 mil than that parallel to the Squegge direction,so Insufficient Solder may occur.I think you may slow printing speed or widen appertures to resolve it.
Electronics Forum | Tue Apr 08 08:39:29 EDT 2003 | davef
Good or not, try these: * http://www.vhdl.org/ * http://www.designers-guide.com/Forum
Electronics Forum | Thu Apr 24 09:03:19 EDT 2003 | jgregory
Thanks Dave, great info! I will be looking into your recommendations. Our AmeriVacs unit is lacking in the robust design department as far as I'm concerned. I don't like the pliable rubber sealers. They deform too much. Jason Gregory
Electronics Forum | Wed Apr 23 22:06:46 EDT 2003 | davef
Download it from IPC.org. About as a fast as you can get. They overnight it to you, also.
Electronics Forum | Thu May 01 23:08:37 EDT 2003 | caldon
Dave's point is right on the money. This would be a destructive test..needing microsectioning. Cal Communications Test Design, Inc
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400