Electronics Forum | Fri Nov 30 05:28:12 EST 2012 | d0min0
Hello, we are starting with the flex pcb production, can anyone advice a company in europe that is capable of design and manufacture palett / carriers / frames that allow to produce flex boards in standard smt process regards
Electronics Forum | Mon Dec 10 03:51:03 EST 2012 | odedkal
Hello, I work in a company in Israel that among other things, design and produce pallettes for flex pcb's. Plaese see our page if it is still relevant. http://www.aradmetal-p.com/arad_home Thank you
Electronics Forum | Fri Feb 01 18:07:36 EST 2013 | pnguyvu
Mauricio, Contact Steve@usastencils.com - He'll make you a free first article to try out USA STENCILS INC design and manufacture in house so it'll be very fast.
Electronics Forum | Wed Feb 06 14:55:15 EST 2013 | davef
I doubt anyone will send you the gerbers for the Benchmarker board. Here are my notes on the board: BENCHMARKER II TEST BOARD * Heraeus Materials Technology LLC [Benchmarker II test board that streamlined material testing for rapid customer support,
Electronics Forum | Thu Feb 07 06:58:28 EST 2013 | davef
If that's the case, then talking to eLPe design might be the most direct route to getting the information you need.
Electronics Forum | Tue Feb 12 15:28:19 EST 2013 | pnguyvu
You need a good designed stencil. Contact Steve - He'll make a free article stencil to try out below is his contact info. Steve@usastencils.com 714-636-6211 Good luck!
Electronics Forum | Fri Mar 15 15:28:33 EDT 2013 | anvil1021
I agree that it would be easier to cut the trace or traces, but the issue is that there is a 1.2v line that is tied to that specific ground (design issue) and if we cut it then the 1.2v wont be available to the several hundred traces that are involve
Electronics Forum | Wed Mar 20 12:41:03 EDT 2013 | srinu10136
Rigid flex is a PCB Which is flex circuit and rigid in fabrication of internal layers. This allows the designers to fabricate a single circuit with improving performance. click here to know more details.
Electronics Forum | Fri May 17 14:56:21 EDT 2013 | davef
There's not supposed to be any effin 'drain hole.' Where's you get that from? Read this: http://blogs.smtnet.com/smt/other/qfn-btc-design-guidelines-thermal-pads-etc/ BR davef
Electronics Forum | Tue Jul 30 12:19:20 EDT 2013 | jorge_quijano
You can try by designing your own fixture to ensure the FiFo, but it will always depend on the operator to fill it in the righ order, I used to have a fixture like the one in the image, but it was installed next to the machine, not inside the fridge.
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400