Electronics Forum | Fri Aug 21 09:25:58 EDT 1998 | Energy Technology Systems
| How about live scheduled chat via ICQ ( or other means)? Chat via ICQ may not be the best venue for more than a few users. We are looking into other means, including setting up a chat room on our site. We should have a prototype design within 2-3
Electronics Forum | Tue Aug 18 10:18:22 EDT 1998 | Dave Hulbert
I have a question on tenting of vias on PWB's. I have designed a 6 >layer, military, mixed components (all on top side), LPI soldermask >board which will be run over the wave. I was planning on tenting vias >but did not specifically specify that on f
Electronics Forum | Mon Aug 31 14:03:41 EDT 1998 | Bill Childs
I have a question on tenting of vias on PWB's. I have designed a 6 | >layer, military, mixed components (all on top side), LPI soldermask | >board which will be run over the wave. I was planning on tenting vias | >but did not specifically specify tha
Electronics Forum | Mon Aug 17 19:43:43 EDT 1998 | Bill Schreiber
Smart Sonic has a new Model 2003 Stencil Cleaner that is designed to clean SMD adhesives, solder paste and post solder flux residue from wave solder pallets, oven air amplifiers, etc. all in the same system at the same time with the same chemistry. C
Electronics Forum | Thu Aug 06 12:58:35 EDT 1998 | Paul J. Lingane
Is there any problem using SMT on gold boards? 15 years ago we were told not to use gold boards, but I can't remember why. Judging by the other postings it now appears to be common. Only problem I see is that the nickel should be plated, not elect
Electronics Forum | Mon Jul 20 12:58:51 EDT 1998 | Dew Lolly
QFP's are best left the professionals. There are MANY subtle issues with fine pitch lead forming such as critical tool design issues ability to check critical dimensions etc. Unless you want to replow this grown in hopes of getting a promotion or c
Electronics Forum | Thu Jul 16 12:50:36 EDT 1998 | smd
200 boards an hour and probably does. Our slow P&P machine keeps us from getting that benefit. But we get to have all the headaches. I think the printer runs on a 286! That's pretty sorry for such an expensive piece of equipment. The stencil frame is
Electronics Forum | Tue Jul 14 13:47:53 EDT 1998 | Mark Barnett
There's a battle brewing around here regarding the use of press fit connectors in place of their thru hole counterparts because of suuposedly better reliability. Is there any validity to this statement? Up until now, we have only been going with pr
Electronics Forum | Tue Jul 14 10:24:33 EDT 1998 | JMCoogan
Wayne We (Universal Instruments) started demonstrating the placement of 0201 chips at the last Productronica show in Germany. But at this point in time, you will be hard pressed to find anyone using it in production (although the placement equipment
Electronics Forum | Sat Jun 20 00:22:12 EDT 1998 | Arul vanan
Presently many of our boards are wave soldered with 0603 chips on the bottom side, with soldering PPM level of 500 PPM. Apart from dispensing the glue we do screen print the glue depending upon the product maturity. My question is, 1. Can we print t
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
