Electronics Forum | Tue Jun 02 16:02:13 EDT 1998 | Earl Moon
| First of all let me say that we are currently placing other 240 pin QFP'S with no problem. But none of them have the MASS of this beast. | The part is a XILINX XC5215-6HQ240C which has a large metal heat sink covering most of the bottom of the part
Electronics Forum | Tue May 26 16:59:47 EDT 1998 | Gary Simbulan
I know, I've read the "been there done that" stories about this subject, but I still profess ignorance on some aspects. We are using NPO type dialectric caps in potted high voltage assemblies and continue to experience catastrophic vailures. Upon
Electronics Forum | Wed May 27 15:00:32 EDT 1998 | Scott Cook
| The question raised by our components engineering group is, is it possible to tell whether these failures are thermally or mechanically induced. The focus of design engineering up until now has been on process. Are our reflow temps ok, are the pa
Electronics Forum | Tue May 26 14:42:55 EDT 1998 | Justin Medernach
| We currently bake plastic SMT parts in accordance with the IPC guidelines for moisture sensitive parts. Because we have double-sided boards that are subjected to either an aqueous or semi-aqueous cleaning process, we do a 24 hour bake at 125 deg.
Electronics Forum | Thu May 21 17:16:03 EDT 1998 | Cunli Jia
| We applaude you for your fine efforts and providing us all a place to lodge our intelectual information. Some of us were talking and wondered if you might help us with a place to park some of our past technical (non commercial) articles as a way of
Electronics Forum | Fri May 22 09:19:12 EDT 1998 | Chrys
| | We applaude you for your fine efforts and providing us all a place to lodge our intelectual information. Some of us were talking and wondered if you might help us with a place to park some of our past technical (non commercial) articles as a way
Electronics Forum | Tue May 19 18:56:29 EDT 1998 | Dave F
| | Earl, | | I admit that I missed your article since I seemed to have let my subscription to Circuit Fabrication Magazine expire. I am interested in your experience in this area. Is there a way to get a copy of your paper? Could you maybe post i
Electronics Forum | Tue May 19 16:32:54 EDT 1998 | Chrys
| | Earl, | | I admit that I missed your article since I seemed to have let my subscription to Circuit Fabrication Magazine expire. I am interested in your experience in this area. Is there a way to get a copy of your paper? Could you maybe post i
Electronics Forum | Sat May 16 19:31:27 EDT 1998 | Graham Naisbitt
Gentlemen, Please consider that ionic testing is designed only for detecting ionic contaminants. Yes there are instances of non-ionic contaminants that cause premature circuit failure. However, more importantly the prevailing specs are less than adeq
Electronics Forum | Mon May 11 17:35:01 EDT 1998 | Steve Gregory
On 11 May, 1998 Todd wrote: | We are having continuous bridging problems with the trailing | leads on a 26-pin D-sub through-hole connector. The pitch is | 0.100". The connector is going through the wave at approximately | a 20 Degree angle. Does