Electronics Forum | Thu May 26 13:48:34 EDT 2011 | jorge_quijano
I used this for a couple of weeks some years ago, I was able to detect some issues whith some stenciles, but I did not use it for a long time, it may help you.
Electronics Forum | Thu Jul 21 07:21:47 EDT 2011 | ccouture
So far after ~1500 units printed with the stencil treated once with Rain-X, no issues were detected with solder joints. The only difference is no more solder bridges on fine pitch with .010" openings. The print is picture perfect on all pads, nice an
Electronics Forum | Mon Sep 12 10:58:03 EDT 2011 | 4kevinl
What kind of equipments you were using to detect lead? Has any existing regulation to setup the limit of lead content to determine the lead free process?
Electronics Forum | Tue Nov 15 15:40:52 EST 2011 | jdengler
Do you have any trays in the location you are trying to pick from? The Z axis should move until it detects the top of a tray. Without any trays it may not function correctly. Also some machines will need an empty tray below the tray you want to pi
Electronics Forum | Tue Sep 18 13:07:52 EDT 2012 | mark25y2001
MPAG3 is capable to detect bend pin in up and down form... but i advice to read both machine specs and compare base on your production need for a wise and best machine selection.
Electronics Forum | Tue Oct 16 10:39:35 EDT 2012 | trottmann
Hello, are you useing any Through hole AOI in your conventional Hand Assembly and what Typ is it pre- oder post-solder? And what errors are you ecpecting to detect? -missing component -component Offset -polarity Check -or??? Is there Any Manufactu
Electronics Forum | Fri Apr 19 01:42:35 EDT 2013 | dman97
Sounds like you need to run the MINT program. Boot the machine into MSDOS mode change directory to mint and type load. Let the machine auto detect the cards and re download the software to all cards.
Electronics Forum | Sun Jun 16 15:14:55 EDT 2013 | mbb
Hello, We are using Panasonic as pick and place Machine with joint detection mechanism. Operators are spending so much time in splicing operations. I would like to know if there is any tool or machine to do automatically splicing (with less time spen
Electronics Forum | Mon Nov 25 00:45:35 EST 2013 | igorfo
Thank you for advice, But main concern how to detect the problems with BGA on SMT line, and how I can validate "good" or "bad" profile. PS: SPC said that process Cpk 2, temperature profile in the upper spec limit for TAL and peak temperature.
Electronics Forum | Thu Jul 09 15:17:48 EDT 2015 | goodting
Thanks for the inquiry. We used MCD (Motion Control Dia) tool to verify if that is caused by VRM board. No respond(I means the related axis was off) was detected. we swapped that board to other machine, the VRM card was good.... X axis was stopped, t