Electronics Forum: dfx (Page 1 of 2)

Edge Clearance

Electronics Forum | Wed May 03 12:10:20 EDT 2006 | jax

Most, if not all, DFX guidelines are Equipment dependant. You can provide standard requirements in your DFX guidlines (edge clearance, component keep-out, height restrictions, etc...) along with an exceptions report for increased cost. just a though

share the DFX Design Guideline

Electronics Forum | Mon Oct 05 05:08:45 EDT 2009 | pengliang

Hello we'll share DFX Design Guideline as attached i hope dicuss with you MSN:liang.pung@hotmail.com

DFX guideline

Electronics Forum | Tue Feb 03 22:38:22 EST 2015 | slouis2014

Hi guys. I need to update the existing DFX guideline (PCBA) of our company, the last revision was 2009. Their's a lot to update for the latest technology nowadays. any document recommendation is very welcome.

share the DFX Design Guideline

Electronics Forum | Tue Oct 06 15:49:13 EDT 2009 | davef

As a start, consider running 'spell check' if you intend to keep the English portion.

DFx

Electronics Forum | Tue Aug 21 17:23:23 EDT 2001 | davef

A worthy endeavor. Consider checking the fine SMTnet Archives. Searching on df* lists almost 200 postings between the "Design" and "Production" Forums. Further, check the SMTnet Newsletter. Earl Moon wrote some very good articles on DFx. The art

any comments about VALOR?how about the DFM software ?

Electronics Forum | Tue Jul 30 20:34:59 EDT 2002 | scottxiao

Hello, Gang, the following link have some discussion about Valor: http://dfx.51.net

PCB manufacturers

Electronics Forum | Thu Jul 29 14:20:29 EDT 2010 | davef

On the web, find a magazine called "PCB Fabrication & Design" or something like that [ http://www.pcdandf.com/cms/ ] Usually, DfX rules are rolled into the board layout CAD

DFM REPORT

Electronics Forum | Mon Jul 09 20:55:15 EDT 2001 | davef

Very clever posting this thread on the SMTnet Site Support Forum. As the previous poster implied ... WHAT???? Your question is unspecific. In the most basic sense ... Design-For-"X" (DF"X"). The value-added service of instituting "best practice

Selective Soldering Equipment

Electronics Forum | Wed Dec 05 22:59:42 EST 2007 | er_pe

To be successful, and to yield quality products off any selective solder systems out there on the market today, DFX rules need to be enforced and followed. Lay-out is a one-shot process where as manufacturing of the PCBA is continuous. Obviously, muc

DFx

Electronics Forum | Tue Aug 21 13:20:47 EDT 2001 | LloydG

Greetings! I would appreciates any inputs to all tech pros & Engineers: As responsible for manufacturing engineering for our PCA products(OEM/Telecom) am planning to implement a company-wide implementation of DFM/DFT. Am looking for a software that w

  1 2 Next

dfx searches for Companies, Equipment, Machines, Suppliers & Information