Electronics Forum | Mon Aug 17 11:29:41 EDT 2015 | deanott
Thanks for the useful instruction. We did find a loose connection. It was the connector right at the camera/PCB. I believe it was bumped when placing board supports (going forward we'll move the camera to the rear when placing board supports).
Electronics Forum | Fri Oct 16 20:12:33 EDT 2015 | billthebuilder
I ended up just making a new test board as we had some specific PnP abilities we wanted to test, but I did follow up on your link and got a quote. The dummy components were way cheaper than what we bought from Digikey or what I saw on Topline. This w
Electronics Forum | Mon Sep 26 05:51:50 EDT 2016 | sophyluo1985
Dear James, How are you? I remember that you found the solution to calibrate the Siplace X feeders last year. Did you get the way? I'm also want to know how to calibrate the feeders. Could you please teach us the way to calibrate Siplace X feeders? T
Electronics Forum | Tue Dec 01 12:58:09 EST 2015 | ttheis
When ever I did an autotune the machine would start at 100F on all three zones, then after a long time it would bump up to 200F and finally 300F. It takes forever but eventually it would complete the tune process and be ready to enter work mode.
Electronics Forum | Wed Feb 17 13:02:03 EST 2016 | comatose
The layer count itself isn't going to be what drives yields. What is the trace/space? How much annular ring for vias did you give them to play with? Class 2 or class 3? What's the worst hole aspect ratio? Controlled impedance? The closer you run to y
Electronics Forum | Fri Feb 19 15:23:31 EST 2016 | ttheis
RESOLVED I adjusted the "Minimum Board Width" in the Board Handling Configuration to resolve this issue. I set the lane width to a larger value which did not hit the front limit and measured the difference between the actual lane width and the set l
Electronics Forum | Tue Mar 22 14:50:11 EDT 2016 | ttheis
A friend of mine has a used gsm1 but when loading up UPS it gives an error indicating it did not receive a request to load the machine model in the allotted time. Photo is attached of the message. Any suggestions what to look at? The machine is runni
Electronics Forum | Thu Jun 02 08:21:57 EDT 2016 | buckcho
I will tell from my personal experience - I used Omron VT-RNS and it had issues, like the previous post. 0402 components, transistors and SMA's had problems, but when you have experience you can come up with some additional ideas (like look for the t
Electronics Forum | Thu Jun 02 15:16:54 EDT 2016 | dilogic
I did try to null the axis - no improvement. I have AMC software and tried (almost) everything related to electronics (except for changing linear encoders, but this seems to be OK - when I move axis manually, position numbers change smoothly). It loo
Electronics Forum | Wed Aug 31 17:23:00 EDT 2016 | corepride
Hi everyone, I have a problem with the 630 VME vision system: during startup machine, an error popup appears saying "Did not receive request to load machine model within timeout period. Possible machine error condition exists. Do you want to continu