Electronics Forum | Tue Apr 13 14:14:59 EDT 2004 | russ
I have actually printed this same condition with type 3 paste Alpha WS709. I posted this for discussion and cannot remember what I called it. We did need to clean the stencil after every three prints. I did not check volume on these locations but
Electronics Forum | Sat Dec 18 00:00:26 EST 2004 | vinitverma
Hi Rob, I did'nt want to reply, but Base did, and rightly so about the dates. But that's not we're discussing at this moment. We started discussing about what's best for Serge. Now that he has decided for the NXT, good luck to him! But serge, in ca
Electronics Forum | Mon Feb 13 11:02:05 EST 2006 | Alan
Hi Grant, Does the Flex mag have the corect pal chip in it? Some of the early Flex mags had tm8 pal chips in them. On the machine this did not have much of an effect (it did at one time allow you to have the hydra pick from the flex because the mach
Electronics Forum | Wed Jan 12 12:11:51 EST 2005 | Grant
Hi, Are you coating the bottom of the palette with flux? What's the material of the palette. I have not seen that, but we did have some weird problems when we did not add flux on a virgin palette, but once it dirtied up a little it was ok. We had
Electronics Forum | Fri May 26 09:43:52 EDT 2006 | smteng0201
We looked at YESTech and found that they not only lowered their inspections scores to decrease their high false call rate, but more importantly they missed actual failures. In the big picture, I would rather have the chance to look at something and
Electronics Forum | Wed Jul 06 20:33:39 EDT 2005 | davef
Pat In response to your questions: Q1. How did you measure the area reduction (loss of weight or reduction of diameter/thickness)? A1. We measured the starting and ending diameter. Then calculated the area [assuming symmetry]. Q2. How did you tak
Electronics Forum | Wed Aug 17 10:46:48 EDT 2005 | pjc
MPM did not discontinue the camera, the camera manufacturer did. It�s not a custom made camera for MPM. Try searching used or second-source cameras. There are three types of vision systems offered on the SPM: manual cross-hair, semi-auto and high-res
Electronics Forum | Thu Nov 03 09:50:45 EST 2005 | slthomas
"Besides I did say they would do a job." I know you did....note I was responding to a previous poster. ;) I mutter something under my breath about our Quads daily. They reject simple parts randomly for no apparent reason, refuse to align some no ma
Electronics Forum | Fri Feb 17 14:00:26 EST 2006 | DannyJ
Baer, Sara, et al., Thank you all for your responses. I apologize, we have a new line installed and have been quite busy the last month... I'm downloading the video as I type this from pkay. Samir, please, if you get the sample and give it a tri
Electronics Forum | Fri Feb 24 13:49:09 EST 2006 | stepheniii
About 8 years ago when I looked up IC data sheets, I would find the reflow temperature tolerance data for them. (i.e. can withstand 280C for 180 seconds or whatever) I wasn't looking for that info at that time but noticed on at least some data sheet