Electronics Forum | Wed Jan 26 01:39:12 EST 2005 | sohct
Is there a procedure for the this test? If yes please forward to me. Thx.
Electronics Forum | Mon Nov 26 12:00:20 EST 2001 | peterson
Hi everyone, I am looking for a reliable company (preferrably on the west coast) that can make Wave Solder and Press-Fit fixtures for our back-plane division. I need a reliable source that can take our data and produce quality fixtures in a 5-7 day
Electronics Forum | Thu Oct 21 16:08:16 EDT 2004 | Dzyna Kid
Does anyone know of any resources I could investigate to make a small circuit that would consist of a transmitter, receiver, and a motor. I want to be able to press a button on a remote control and that would make the motor turn on, then I want to b
Electronics Forum | Wed Jan 26 09:27:41 EST 2005 | davef
Look here for more on dye & pry: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=25007
Electronics Forum | Tue Jun 04 19:33:16 EDT 2002 | rob_thomas
Dave's estimation is pretty conservative but there is a lot of equipment out there and a lot of people happy to make a sale.Implementing both mentioned processes it's difficult and time consuming .Even if you get good training from whoever sells you
Electronics Forum | Tue Oct 09 14:10:24 EDT 2001 | cal
I am confused. You are using pressure sensitive tape. the pessure sensitive tape i have seen does not use cover tape.The pressure sensitive tape I am familiar with is called "Surftape" could you provide some more clarification?? Surftape is more co
Electronics Forum | Thu Oct 11 13:37:35 EDT 2001 | Stefan
The pressure sensitive tape is used as an alternative to heat sealed cover tape. It works usually quite well and is easily applied by the taping machine, but it can create some problems in the tape feeder. In the Surftape, Cal is referring to, the c
Electronics Forum | Mon May 07 22:29:52 EDT 2001 | davef
4 wire per sec ... you figure how many you need] Encapsulation ~$120K for a dispenser [10 sec per die ... you figure how many you need] plus a cure oven ~$100k Throw in a another ~$100k for marking and cleaning Check the September 2000 SMTnet New
Electronics Forum | Mon Nov 26 12:53:52 EST 2001 | bgaeng
SPPRECION 2660 SE 39th Loop Suite A Hillsboro, OR 97123 Fred Lovingier www.spprecision.com
Electronics Forum | Fri Nov 30 20:11:16 EST 2001 | MARK COPLAN
Give us a call we are manufacturing fixtures in the time frame you asked for Mark Coplan I Source Technical Services, Inc. www.i-source.com