Electronics Forum | Fri Jun 07 14:14:24 EDT 2019 | teejsd
Yes neither our HPLC IC nor our C3 could detect any concerning levels of ionics. Soaking over a weekend sounds like a good idea, though I may still need to cut the board down to fit our Kapak bag size. And get our silicone coating off the surface. K
Electronics Forum | Sat Apr 27 09:47:27 EDT 2019 | SMTA-Joe
Hello SMTA, We currently use Solder Stencils for installation/rework of QFNs/BTCs, and have tremendous success with them. While they aren't overly expensive considering their high quality it does seem like a waste of money to purchase more screens
Electronics Forum | Wed May 01 14:22:48 EDT 2019 | stephendo
There was a British reality show where they dropped scientists different places and gave them challenges. One place was in New Zealand near an old gold mine. One task was to purify gold with the materials they had on hand. Take a wild guess what they
Electronics Forum | Thu May 09 11:37:12 EDT 2019 | slthomas
I'm curious about what you guys do for Pb-free HASL profiling. We seldom see this finish (only on consigned boards or if they specify it directly, which is very rare) so we don't have a lot of experience. Certainly we get better results with high
Electronics Forum | Sun Jun 23 02:16:47 EDT 2019 | emanuel
Some manufacturers put very strong glue, the wider the part is so increases the glue strength. May sound funny but the only thing that worked was attaching a fishing weight to the tape, need to play a little until you find the correct size. The only
Electronics Forum | Tue Jul 02 10:27:31 EDT 2019 | BigFuji642
I tried using the cable on page 4. The DB9 to DB25. Is that the correct one to use with a USB to DB9 adapter? What is the difference between using MCS and C/C for communication? Which one should I be using and how do I see which one is being us
Electronics Forum | Fri Jul 19 11:09:29 EDT 2019 | BigFuji642
Yes we have the hard copy of the proper data on a floppy disc. If we do not have the correct Proper Data, could it give me the error below? I was thinking it would make it past the log onto machine comm server stage, and then have a different err
Electronics Forum | Thu Jul 18 17:41:31 EDT 2019 | rgduval
The UFP was a designation for "ultra-fine-pitch"; but, for the most part, you should be able to get the same placements out of both machines. Anything 0402 or above can be mechanically centered. The UFP machine will lean on optical centering for .5
Electronics Forum | Fri Aug 02 12:03:16 EDT 2019 | dfl
UPDATE: I was reading around about similar problems. My function #30 always return nozzle height 1. I tried to clean up the glasses and the internal laser lenses, no go, still at height 1. Even after removing both glasses, still at height 1. I saw s
Electronics Forum | Fri Aug 02 14:03:34 EDT 2019 | aaronhodge
Thank you for the reply. My concern isn't with each doc having different Revs. I believe the part that I'm struggling the most with is that the product drawings contain no mention of components or a BOM whatsoever. It's as if there is nothing to ti