Electronics Forum | Sat Sep 26 19:09:17 EDT 1998 | Graham Naisbitt
As an addendum to Daves posting, please consider that: There is no such thing as no residue fluxing. A no-clean must herefore, have benign residues - in other words, they are not as efficient at removing surface oxides to enable good solder joints. S
Electronics Forum | Thu May 28 07:25:58 EDT 1998 | Earl Moon
| Hey yooze guys! | Enough of the jokes between you and Earl (GRIN), let's get back to the topic...well, okay... you can tell a few more...(but good ones, 'kay?) | Anyhoo...I'm not sure if ya'll are on the IPC Technet list or not, I've not seen any p
Electronics Forum | Thu May 28 05:43:33 EDT 1998 | Earl Moon
| Hey yooze guys! | Enough of the jokes between you and Earl (GRIN), let's get back to the topic...well, okay... you can tell a few more...(but good ones, 'kay?) | Anyhoo...I'm not sure if ya'll are on the IPC Technet list or not, I've not seen any p
Electronics Forum | Wed Apr 15 15:04:18 EDT 1998 | D. Lange
| | | | We are having a bridging problem with SOIC 14,16 and 20 pin devices during flow solder of the bottom side of our boards. This bridging occurs about half way up the lead between the board and the body of the IC. The chip parts are no proble
Electronics Forum | Wed Apr 15 14:57:20 EDT 1998 | D. Lange
| | | | We are having a bridging problem with SOIC 14,16 and 20 pin devices during flow solder of the bottom side of our boards. This bridging occurs about half way up the lead between the board and the body of the IC. The chip parts are no proble
Electronics Forum | Wed Apr 15 14:53:06 EDT 1998 | D. Lange
| | | | We are having a bridging problem with SOIC 14,16 and 20 pin devices during flow solder of the bottom side of our boards. This bridging occurs about half way up the lead between the board and the body of the IC. The chip parts are no proble
Electronics Forum | Mon Apr 13 08:47:09 EDT 1998 | Bob Silveri
| | | | | | | We are having a bridging problem with SOIC 14,16 and 20 pin devices during flow solder of the bottom side of our boards. This bridging occurs about half way up the lead between the board and the body of the IC. The chip parts are no
Electronics Forum | Mon Jan 28 08:07:44 EST 2002 | JohnW
Sorry I keep forgetting you lot are backwards in the old metric system :0) anyhoo, yes IPC, the bastions of right well as long as your board is only 1.6mm thick (sorry 62mils)say that you need 75% min general and 50% on ground planes. I'd like to se
Electronics Forum | Tue Feb 19 13:37:48 EST 2002 | PeteC
When evaluating AOI you must first define what type of inspections you want the system to perform, pre-solder or post-solder. What separates many mfgs. of these systems is how effective they are at finding post solder defects. This is where camera re
Electronics Forum | Tue Apr 09 21:40:26 EDT 2002 | ianchan
We are a local enterprise with limited resources, just like you described, so hope this experience sharing helps : we place a production Visual Mechanical Inspection (VMI) inspector at the end of each Reflow Oven area, complete with magnify scope 30