Electronics Forum | Thu Sep 15 10:43:18 EDT 2016 | claudea2
Thanks to Bobpan we re connected our wipe system and all the air actuators work fine. I still have a problem with the cleaner fluid dispenser. It is not moving as it should to dispense the liquid when we do the command. I suspect the values in the c
Electronics Forum | Thu Jul 20 17:01:26 EDT 2000 | Bob Willis
Here is some further information on SDSRS process, but please purchase a copy of the report from t he SMTA as all the money goes to charity. In the UK the SMART Group raised over �3000 for the homeless. SMTA have been raising a lot of money for the G
Electronics Forum | Thu Jul 20 15:08:53 EDT 2000 | Bob Willis
Yes no problem here it is in a nut shell. The sponsor of my CD ROM on this process was Loctite who specifically developed a glue for the process to cure in less than 10seconds. Have a word with these guys they may even have a few CDs. PROCESS SEQUEN
Electronics Forum | Mon May 28 07:30:52 EDT 2001 | bobwillis
Here is a draft visual inspection guide for underfill, please pass this on to the relevant people for any comments or suggestions. I am currently working on the pictures to go with the reference guide. Flip Chip/uBGA Underfill Visual Standards The
Electronics Forum | Mon Aug 09 14:58:33 EDT 1999 | Earl Moon
| | Earl, why don't you post this ALSO in the "Mart". Is there a reason? | | | | | | | | | | | Folks, | | | | | | | | | | Probably not the forum, but forgive me as I am but a dog as described by Justin and admitted by me. However, I am looking fo
Electronics Forum | Mon Jul 26 14:14:51 EDT 1999 | Steve Gregory
| | | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is th
Electronics Forum | Sun May 23 07:13:56 EDT 1999 | Scott Cook
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
Electronics Forum | Fri Dec 08 19:08:52 EST 2000 | Mike Konrad
I do not know which specific flux you are using, but here are some general guidelines. If your wave soldering machine uses a foam fluxer, then there are foaming agents in the flux. Under �normal� conditions, the volatiles (including the foaming age
Electronics Forum | Sun Aug 06 14:02:04 EDT 2000 | David Harper
The company I work has been assembling this particular board for several years now, and one thing has always remained constant. Bad Soldering. The board is a double sided board, the solder side has about 250 1206 caps & resistors and Sot-23 transisto
Electronics Forum | Mon May 29 02:15:06 EDT 2000 | Dreamsniper
Hi Buddy, We've tried shifting to this process before and from our point of view here are some of the advantage and disadvantages that we discovered. Advantage 1) Cheap Equipment cost as you just need to use your Solder Paste Printer rather than buy
A Manufacturer of High Quality, Precision, Automated Fluid Dispensing and Conformal Coating Systems, SMT Cover Tape Peel Tester and Lead Forming machines for through-hole component preparation.
611 Hollingsworth Street
Grand Junction, CO USA
Phone: (970) 245-0408
