Electronics Forum | Fri Jun 24 12:03:58 EDT 2005 | ehess
I am looking for some info on our Kenco Industries, Ionic Tester. I've searched the internet, but cannot find them. Tag says Atlanta, GA, but search brings up nothing. Does anyone out there have one of these, and do you know where I can get parts?
Electronics Forum | Tue Jun 28 19:56:20 EDT 2005 | matjen
I am in the process of searching for anyone that does repair on fuji cp6 nozzles .7 & 1.0 mainly, We have an abundance of bent and broken nozzles that I would like to get repaired rather than throwing out so if anyone has information on this please
Electronics Forum | Wed Jun 29 17:35:46 EDT 2005 | Hiram
Hi all, Does anybody have any comments on the lead-free alloy SN100C from AIM solder? I am in the process of selecting the "right alloy" for our lead-free wave solder machine. We manufacture A/V equipment. I appreciate your feedback as usual. Hir
Electronics Forum | Thu Jun 30 09:55:32 EDT 2005 | slthomas
Is this happending consistently with every board? I guess if it is (so is easily reproduced), I'd run boards in with the lid down, then open it when the tunnel is full and see which boards still have all the parts in place. At least then you'll kno
Electronics Forum | Wed Jun 29 19:33:12 EDT 2005 | matjen
After the machine stops for any reason when restarted the z table goes to loader position comes up then goes back down and re-reads the fiducials, only one machine does this but we are losing valuable cycle time after every part change. We have Fuji
Electronics Forum | Wed Jul 13 09:07:32 EDT 2005 | russ
The reason for going 1:1 with lead free is that it does not spread out like the pb solders. So 1:1 is really not necessary in my opinion. We go 1:1 anyway on discrete components along with other packages. You always have to make sure that the area
Electronics Forum | Mon Jul 18 16:48:54 EDT 2005 | lupo
Hello, According with quality standards TS16949 ,QS 9000 etc. improvement can be perform when the process is stable and capable. So, if DOE is method for improvement it is a good idea, first to run SPC for investigation process stability and capa
Electronics Forum | Thu Jul 14 14:31:11 EDT 2005 | johnnie8
A customer has asked us to solder a surface mount mini USB connector to a board. They need the connector housing to center on an opening in a plastic panel. The question is how much does the solder process add to the overall height of the coonctor, e
Electronics Forum | Tue Aug 23 07:59:53 EDT 2005 | avalancher
That's an interesting fact Ken. Now I think i've seen every figure out there. Let's see, CPH, DPMO, CPK, and now, hmm, what would this be called, PPPSF (parts placed per square foot). Does anyone have a formula on this to figure out my PPPSF?
Electronics Forum | Tue Jul 19 11:53:04 EDT 2005 | CLampron
seaK, Check your PCB Thickness check in your program. See if it is checking the PCB at this location. Each board the machine will check to find the baseline thickness of each board run. It does this with a tool. I'm thinking this may be it because I