Electronics Forum | Thu May 09 11:37:12 EDT 2019 | slthomas
I'm curious about what you guys do for Pb-free HASL profiling. We seldom see this finish (only on consigned boards or if they specify it directly, which is very rare) so we don't have a lot of experience. Certainly we get better results with high
Electronics Forum | Mon May 13 03:37:41 EDT 2019 | relaycz
Hi, I work at an electronics manufacturing company and right now, we are selecting a new screen printer instead of our old Samsung SP-450. Does anyone have some experience with these machines or at least manufacturers? These ones are basic and sim
Electronics Forum | Thu May 23 12:27:19 EDT 2019 | weglimir
Hello I have problem with card: VPM-5238D - Namely when printer starts, and DEK program initializes, it hangs for a while on "Downloading vision system" and then following error appears: "Vision Hardware Error - FATAL ERROR - REINITALIZE MACHINE" "
Electronics Forum | Wed Jun 05 15:15:37 EDT 2019 | cristian_amlima
Hi Guys.. greetings! I hope someone could help me. Does anyone knows how to configure a gripper nozzle to juki 700 series? (more specifically FS730). With this nozzle the machine should blow to inflate the nozzle and I don't know how to change from
Electronics Forum | Mon Jun 10 08:51:01 EDT 2019 | don_julio
Thank you Clare. After doing some more research, I found they are known in the industry as "Carriers". I did look into that durostone material. They prices are beyond reasonable. My trek now is seeking a material to make planks out of to lay the b
Electronics Forum | Fri Jul 19 13:19:25 EDT 2019 | BigFuji642
I have not imported the data to Flexa yet. I will have to find a floppy drive. You mentioned below converting the proper data using a MCS. I thought MCS stood for Machine Communication Server. Does it mean something else? How do we convert it us
Electronics Forum | Tue Jun 25 09:38:51 EDT 2019 | davef
SMTA David posted a question about reflow profiling, but it was included in a question about an SMTA training course. I'm reposting it here in hopes of getting him a better response and because we haven't developed proper methods to communicate with
Electronics Forum | Sun Jul 21 10:33:53 EDT 2019 | reckless
I use a lead free 3 zone essemtec oven which I love. It's on the smaller side (wish it was even smaller). It works fine in our application. Maximum width is 300mm and only uses 5-6kwh average (25A max). Made in Switzerland. For some reason I don
Electronics Forum | Wed Jul 17 17:56:38 EDT 2019 | rgduval
Check the MOT board. You can usually swap out the individual MOT boards, and see if the problem moves. If it does, you can isolate which board has gone bad. You can also check the encoder on the conveyor, to make sure that is still working correct
Electronics Forum | Thu Jul 25 07:50:37 EDT 2019 | jmedernach
Hi Folks, It's been a coon's age since I've been on here. I'm wondering if the community can't help me out with something. "Back in the day" there were thermocouples made by Saunders, Temprobes, with a design that would clamp on the board edge. Yo