Electronics Forum | Wed Mar 13 13:08:31 EDT 2024 | lambert
Section 8 in the J-STD-001 was the initial place to start with cleaning and the requirements, however with all the changes going on within the industry with increase product densities and such, a revision is being created to help understand the need
Electronics Forum | Sat Mar 30 14:02:48 EDT 2024 | poly
I've bought a used ky 8030 spi that has a software fault. I've got the software restore from Koh Young but i can get any debugging info to see if the hardware works. I assume win mcs is the interface to the hardware but all the debugging options are
Electronics Forum | Mon Apr 08 17:27:36 EDT 2024 | kingkelvin
I found a 0.9mm hex tool - but if I adjust the indicators "all the way up" on the shaft I get all current ranges at 255 (so obviously too high on the shaft) but if I place it anywhere else on the shaft (slightly down from top, or all the way down as
Electronics Forum | Sun Oct 08 17:18:31 EDT 2000 | Scott
I have a problem, I have a radio control unit, which I need to power some low voltage lighting, the radio control unit is also used for two other items so I need to use it, the problem is that the current spike that is required when turning on the lo
Electronics Forum | Wed Oct 04 14:54:46 EDT 2000 | Sean
I feel Woldgang poses an interesting question. It seems you have already decided that dispensing is the path you wish to take. Yet can you tell us why? Is there a flexibility vs. throughput arguement here? Justification of dispense via the cleani
Electronics Forum | Thu Mar 16 14:04:14 EST 2000 | Cartman
Greetings. My company has a VOC-Free no-clean wave solder flux with 4% solids. I have a number of questions as they relate to our ICT Fixtures. Currently, we're encountering the following issues: 1.) PM on probes....What is the recommended PM p
Electronics Forum | Wed Feb 07 21:56:00 EST 2001 | davef
Every critter out there with large incisors adapted for gnawing and nibbling has a different theory of solder ball formation. [My theory: It�s punishment for using NC fluxes. Stand and deliver. My solder balls end-up in the gross filter connected
Electronics Forum | Wed Mar 28 18:23:48 EST 2001 | Mike Konrad
Hi Bill, Please let me refresh your memory� On April 1, 1999, the United States Environmental Protection Agency sent you a letter based on what they called �inaccurate� statements made by SmartSonic (ironically on SMTNET.COM). EPA letter dated Apr
Electronics Forum | Wed Mar 28 20:03:33 EST 2001 | Rob Fischer
This is brutal. I think we should call a truce. Mike has very good points and his quotations from the EPA letter are fact. If there isn't a competitor of Bill's who hasn't seen this letter I'd be surprised. We could go on and on about this and th
Electronics Forum | Thu May 24 16:45:57 EDT 2001 | kmorris
Hi All: We�ve got a problem here with opens on bottom side wave soldered SOT23s. Based on past experience and review of the SMTnet archives, I feel that our main problem is pad size. We have the same size pads for bottom side SOT23s as we have for