Electronics Forum | Fri May 11 07:38:14 EDT 2007 | tombr
It is possible to vary the length of lead during auto insert. However, it requires software and mechanical adjustments. Universal equipment allows small changes via software program for lead length. To change angle of clinch involves a mechanical a
Electronics Forum | Wed May 30 18:34:08 EDT 2007 | russ
make your silkscreen accurate and you do not need vision vision is the reason for the high cost of this equipment. A part like you mention can easily be done with a temp controlled heat gun and a fixed height stand (about 300 dollars total)to hold t
Electronics Forum | Wed May 30 18:42:17 EDT 2007 | russ
I have heard this question before. My thoughts are: If it is inline and being used to monitor the assembly line as boards are produced it would be process related either engineering or Quality assurance /control. I do not think it would be process
Electronics Forum | Mon Jun 18 10:11:52 EDT 2007 | dyoungquist
Almost every board/panel we build is double sided and we use an MPM SPM screen printer with no problems. The screen printer is not the cause. We have seen heavier parts fall off the first side when going through the reflow for the second side. We
Electronics Forum | Mon Jun 25 10:42:43 EDT 2007 | fredc
On our new shop we used iron pipe in the walls and attic and copper ever where else that can be easily accessed. I saw a pvc material at a trade show years ago that was rated for air lines. With their demo material they could fold it and drive nails
Electronics Forum | Wed Jun 27 12:27:46 EDT 2007 | jaimebc
Same error here with our GSM1. Does your GSM have 2 heads? If so, this is how I fixed it. I didn't have a spare Z motor, so I swapped the Z motor for the front head with the rear head. Problem gone. Now since we don't use the rear head as much as we
Electronics Forum | Fri Aug 03 12:31:43 EDT 2007 | jdengler
You probably do not have "Drift". The rotary table and or fixture may not be square. The rotary table can be adjusted. You should have someone who has done this before available to make the adjustment before you try it yourself. You can check the
Electronics Forum | Fri Aug 17 14:16:09 EDT 2007 | mika
No it is not any "western known" standard. Of course it is a binary type of data. But yes, it is possible to trace the RS232 data stream and interpret et the actual info. I know that this has been done before. You might want to just take a phone ca
Electronics Forum | Mon Aug 20 05:53:26 EDT 2007 | erhard
Hello all, we are about to modify a Universal Radial 5 so the machine will be able to insert radial components with lead pitch 3.5mm and 5mm. The 3.5mm components are ELCOs which are getting inserted all the way to the component body so they sit fi
Electronics Forum | Wed Nov 21 15:02:46 EST 2007 | jlawson
From info I have been told from design standpoint, via in pads helps with managing EMC issues with working design, in particular for high speed digital/dense populated type PCB's. We had a manufacturing customer that had very low yield because of th
