Electronics Forum | Thu Aug 22 22:10:26 EDT 2002 | davef
Ooooow! �Can it be fixed?� Good question. How BAD did you damage it? * Since you are asking this question, I am NOT inspired by the potential that you have the skills to fix the board. Go Jeff Ferry�s site at Circuit Repair Center [If you can�t f
Electronics Forum | Thu Jun 23 08:58:00 EDT 2005 | Irene Taylor
We are defining a new assembly process for a double sided card that has 26 BGAs on the top side and 14 BGAs on the bottom side. We currently have one double sided BGA board with one BGA per side and have to epoxy one BGA (35mm X 35mm - 352 ball count
Electronics Forum | Thu Apr 11 11:32:23 EDT 2002 | barryg
Hello everyone. We are interested in doing double sided surface mount. What methods are there for doing this. I know you can wave solder some smt components, but what are the limitations. Is there a method of doing this that uses 2 different solder p
Electronics Forum | Thu Jan 20 20:22:16 EST 2000 | Sam Guilaume
We have run some experiments on double side BGA assembly. Our preliminary results show that complete overlap of top and bottom BGA's indicate fair results, even after reliabiltiy tests (vibrations, temperature cycles, HALT). I will be interested to h
Electronics Forum | Fri Feb 13 03:53:40 EST 1998 | Brian S. Bentzen
Hi , I have not been able to find any good description on how to perform double sided reflow on PCBs.The best would of course be to avoid reflowing the bottom side again but in real life this is not possible. So when double sided reflow soldering
Electronics Forum | Tue Dec 26 15:22:43 EST 2000 | Hussman
Vickij, Why not try using regular temp. paste for both sides? Unless you have some real heavy parts on both sides, you can run a double-sided reflow process with most boards. I myself like to place R's and C's first (or bottom side) and then do an
Electronics Forum | Fri Dec 22 12:17:02 EST 2000 | vickij
Hi! Has anyone out there ever tried to use a high-temp and a low-temp solder paste on a double-sided board without using an adhesive? (Populate the bottom side with the high temp paste, reflow, turn it over, then run the top side). I looked in the
Electronics Forum | Tue Dec 26 11:09:16 EST 2000 | acahill
High temp paste or not, I feel it's all up to the oven,and/or the stencil design. are there sufficient solder joints, before running the opposite side (are the apertures large enough to achieve a hardy fillet or to small, allowing enough paste to vis
Electronics Forum | Sun Oct 31 19:39:26 EST 1999 | Pat Copeland
Parts are falling off on first side when reflowing second side, have tried changing temp profiles, and ended up using tin foil. any recomendations.
Electronics Forum | Mon Nov 01 06:19:45 EST 1999 | Michael Fogel
I suggest tow more ways: 1. try to differ the temperaturte between top and bottom side duering the reflow process. 2. try to add some glue dots under the falling parts befor the placement/reflow process Good luck Michael
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
