Electronics Forum | Tue Jun 13 21:53:31 EDT 2000 | Dave F
This site is dedicated to double sided reflow and solder balls. Wasssup?
Electronics Forum | Wed May 11 10:30:38 EDT 2016 | kahrpr
we use Scotch Removable Double Sided Tape
Electronics Forum | Mon Oct 12 22:35:55 EDT 1998 | Hank Hsiung
Hello, friends: Do you know where I can buy cheap double sided flexible circuits, especially adhesiveless system. Also, when I make double sided flexible circuit assembly, beside using temporary stiffener, any other method to do double sided as
Electronics Forum | Wed Oct 06 04:11:35 EDT 2010 | grahamcooper22
I've done minimal research to this point and > understand my issue with solder on the double > sided boards is due to oxidation that occures on > the unpopulated pads when the board makes its > first trip through the reflow oven. > > We did run
Electronics Forum | Thu Jun 23 08:58:00 EDT 2005 | Irene Taylor
We are defining a new assembly process for a double sided card that has 26 BGAs on the top side and 14 BGAs on the bottom side. We currently have one double sided BGA board with one BGA per side and have to epoxy one BGA (35mm X 35mm - 352 ball count
Electronics Forum | Mon Aug 16 18:37:15 EDT 1999 | Paul Wareham
Is there process by which one can do a double sided reflow (SMT on both sides) in one pass through the oven?
Electronics Forum | Tue Aug 17 16:12:51 EDT 1999 | Doug
| Is there process by which one can do a double sided reflow (SMT on both sides) in one pass through the oven? | Probably not. I have heard people talk of it but never see it done and I wouldn't recommend it. Good luck
Electronics Forum | Wed Aug 18 20:58:12 EDT 1999 | Dave F
| Is there process by which one can do a double sided reflow (SMT on both sides) in one pass through the oven? | Paul: Check Bob Willis' site (check the archives). Ta. Dave F
Electronics Forum | Tue Jun 13 21:18:02 EDT 2000 | sachi
is there a site or any information available for double sided reflow? Our compnay is rather new to this proceess and before we get deep i'd like to know more about it.
Electronics Forum | Tue Sep 14 18:33:38 EDT 1999 | Mark Belec
I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts.