Electronics Forum | Fri Nov 09 13:53:41 EST 2018 | proceng1
We still have an old Heller 1500W kicking around and I can't locate a parts list or manual. I know some "spring cleaning" went on and I'm wondering if someone tossed them. The main issue is the edge rail chains seem to suddenly have a lot of slack.
Electronics Forum | Fri Nov 16 09:28:08 EST 2018 | robl
If you are gang picking from 6 reels in a row for the same part, so the head goes down twice for 12 components, which is easily done on the boards you have previously described, you should see 18K+ per hour with decent panelisation. On an LED panel
Electronics Forum | Tue Jan 15 14:11:12 EST 2019 | griinder
I also use these when available. The problem still persists for Bottom Paste/Parts layer. The non-symmetric(x axis) footprints in the Btm part layer, display correctly in the software, But then display incorrectly when imported into the Printer. The
Electronics Forum | Tue Feb 12 11:26:31 EST 2019 | aldrich17
Does anyone have any info. on an "E869" error code on a Phillips Topaz X SMT machine. Error screen shows "Nozzle down limit sensor is off in A-table YV100X:N2323 YV100XT:n2223 Please check sensor and remove to the cause of this sensor being off.
Electronics Forum | Wed Feb 19 09:15:28 EST 2020 | klofgren
@Evtimov My company only recently got our SMT line operational and are just starting to estimate PCBA time. I just wanted to clarify, it seems that your formula will boil down to the number of panels multiplied by the bottleneck operation. Is there
Electronics Forum | Fri Mar 29 20:07:50 EDT 2019 | sarason
I measured the temperature rise when I built the unit and it has a nice linear rise in temperature over the 3 minutes. I have used the Quikees before. The galcon gas stinks and must be evacuated. The galcon is expensive. The galcon is a perflourocar
Electronics Forum | Wed Mar 27 12:17:46 EDT 2019 | jstebbs89
Hello lads. I run a Sequencer 2596 and have had good luck. Just recently it sounds like air is not making it into the machine. With the machine palmed down it has the required 55-60psi going in, when I release the Estop the psi drops to about 30 and
Electronics Forum | Fri Jun 07 14:14:24 EDT 2019 | teejsd
Yes neither our HPLC IC nor our C3 could detect any concerning levels of ionics. Soaking over a weekend sounds like a good idea, though I may still need to cut the board down to fit our Kapak bag size. And get our silicone coating off the surface. K
Electronics Forum | Wed Apr 24 07:06:56 EDT 2019 | griinder
You need two calibration jigs to calibrate these cameras. There is an L-Type align offset jig that involves removing the front feeder base, and placing the target dot over the middle camera of your front camera bank. After this calibration is done, t
Electronics Forum | Wed May 29 10:28:24 EDT 2019 | etmpalletguy
#1) Is the card in panel form: (Y)/(N) #2) PCB thickness: Thin card: YES, Thick card: See above. #3) is the PCB warping during reflow? (Y)/(N) #4) Is the PCB Symmetrical is shape & size? These are just some of the questions you need to ask yourse