Electronics Forum | Mon Aug 15 18:42:53 EDT 2011 | bandjwet
Does anyone have experience in doing dye and pry analysis on PoPs? A customer wants to know whether or not the board level or device-device interconnect is the suspect. What other technique can anyone recommend? BWET
Electronics Forum | Wed Mar 12 23:00:10 EDT 2008 | davef
You can say: The pad was lifted after reflow and prior to the dye and pry failure analysis. When we see lifted pads, we think: * That's a good solder connection * Either it took a lot of force to lift that pad or the fabrication of the board in the
Electronics Forum | Fri Aug 19 02:16:40 EDT 2011 | ppcbs
In my opinion destructive methods went out with the stone age. At least they did at our company. We specialize in non-destructive defect analysis. We can determine where the failure is i.e. assembly process, fab defect, BGA defect or plating proce
| 1 |
