Electronics Forum | Fri Mar 19 10:08:49 EST 2004 | davef
We don't know dip about your Multitronics 2000 SX, but there may be another angle to take in addition to the Tyco tact that Pete C proposed. The facts may not be precise [someone will hopefully straighten things out], but close enough for your needs
Electronics Forum | Mon Jul 31 15:32:13 EDT 2006 | cardinal
Question: Can an MPM UP 2000 HI E printer recognize Right or Left justified screens? Please let me know. Brad Jakeway Cardinal Circuit
Electronics Forum | Mon Jul 31 16:09:09 EDT 2006 | Chunks
Yes. I have both R-L and L-R machine in house and we swap stencils betweeen them all the time. Stencil programs from R-L to a L-R machine (and vise/versa) will not.
Electronics Forum | Mon Jul 31 16:33:48 EDT 2006 | G.P.
I think he meant stencils where the print pattern is front, left, or right justified on the stencil itself as opposed to being centerred. Is that what you meant. It can be done on DEK printers, but it has been several years that I worked with an MP
Electronics Forum | Mon Jul 31 21:14:30 EDT 2006 | chrisgriffin
Does any one know how far left or right from center the aperatures can be? If I had a 6" board, and a stencil with cut-outs for both sides right and left of center, would I have problems?
Electronics Forum | Tue Aug 01 19:52:19 EDT 2006 | darby
If your frame size is 730mm x 730mm then you can't move it left or right. If it smaller than that then the frame adapter will give you more leeway. I am not too sure by what you mean by "If I had a 6" board, and a stencil with cut-outs for both side
Electronics Forum | Wed Aug 02 14:54:15 EDT 2006 | chrisgriffin
I mean if you are using the same stencil for the top and bottom of a board. Thanks to everyone for the help. From what I gather, it will work when the stencil cut-outs are offset from center in the Y-axis. Doesn't work too good in the x-axis, beca
Electronics Forum | Mon Jul 31 19:52:51 EDT 2006 | darby
TOOLING > OFFSET. The pcb stopper is attached to the camera and a default stop position is calculated from the PCB dimensions. If your stencil image is offset left or right then you can either fiddle the pcb size or input the offset. Offsets front an
Electronics Forum | Mon Jun 29 08:50:55 EDT 2015 | tdemon69
looking for some one that works on these machine for a living, that my company can higher from time to time to do some work on them.
Electronics Forum | Mon Jun 29 09:23:59 EDT 2015 | tnisbet
We service MPM machines. Tom Nisbet firstname.lastname@example.org 603 765-8814 www.goppm.com