Electronics Forum | Fri Oct 15 04:45:48 EDT 1999 | Brian
Cliff Have you done something to your server this morning? The listing is downloading at 18+ kb/s (usually under 4, often under 1 when it is busy your side of the Atlantic). Is it a fluke? Brian
Electronics Forum | Sat Oct 16 05:07:03 EDT 1999 | Brian
I'd have put it myself into the Admin group, but I wasn't able to :-( However, it must have been a fluke: yesterday afternoon and this morning, it was back to its usual snail's pace : 2,8 kb/s today. Pity! Brian
Electronics Forum | Mon Oct 18 08:05:39 EDT 1999 | Doug
Is your firmware version 1.95? In the pd section, do you have the field "auto offset" enabled? Just a couple of things to look at.
Electronics Forum | Thu Oct 14 12:02:44 EDT 1999 | Larry Johnson
I was wanting to know if there was any type of formula that I could use to determine the correct packaging for a SMD For example, if I have the component measurements, can I find out what the correct width and pitch of the tape it comes in should be
Electronics Forum | Thu Oct 14 13:26:31 EDT 1999 | Brian W.
I would suggest comparing the profile your factory used and the one they are using. Run a profile on some of the 0402 parts. If the profile is not right, uneven heating will cause this to occur. It could also be the placement accuracy in combinati
Electronics Forum | Thu Oct 14 13:36:37 EDT 1999 | Brian W.
I forgot to mention nitrogen usage. Check if the usage of notrogen is different in your ovens compared to theirs. Brian
Electronics Forum | Thu Oct 14 18:25:29 EDT 1999 | JAX
Grace, You can get the information you need from IPC. Measuring board warpage is covered in theie 610B manual. It will let you know the what can be reworked and what cannot.
Electronics Forum | Wed Oct 13 18:37:32 EDT 1999 | Brian W.
There is a company in Florida that was using water soluble solder mask with their wash system. The gentleman to call there is Lynn Hurt, their Sr. Staff Engineer. Switchboard number is 352-799-6520. Brian
Electronics Forum | Wed Oct 13 09:15:13 EDT 1999 | Peter Woelflick
Hello, we are looking for usable ultra fine pitch solder pastes with 15-25 um. Does anybody have good or bad experience with a brand/product? If so, please let us know the details. Greetings, Peter Woelflick
Electronics Forum | Wed Oct 13 11:38:49 EDT 1999 | Dave F
Brian: Nicely done. You're correct ... I never "understood" VOC-Free Fluxes. Now, I realize that I understood them, but I just didn't get it. Also, that's for posting this, rather than "going off-line." Ta Dave F
