Electronics Forum | Tue May 07 13:11:33 EDT 2013 | emeto
Hi Hege, there is insulation, which when you look at looks pretty stable.I suspect that there is more heat transfer through the shaft from the propeller to the motor. However when I touch the motor it is not really hot, so I am confused what really
Electronics Forum | Wed May 22 10:39:56 EDT 2013 | emeto
Hi smter, that sounds interesting. I can even buy a wrench with a set torque if it will help. What wrench are you using?
Electronics Forum | Tue May 07 13:22:11 EDT 2013 | ngineer
Yeah, it comes on for a couple of seconds, then trips. When it comes on, before it trips, i can look into where the axis drives are, and the z-axis has a red and green led lit, while the others only have a green one. Then it trips. Maybe that drive
Electronics Forum | Tue May 07 15:30:41 EDT 2013 | bobpan
your card is probably bad.....you can ohm out the motor and cable if you want... z motor windings 1.36 ohms z motor cable and windings 1.82 ohms good luck
Electronics Forum | Wed May 08 05:13:37 EDT 2013 | bobpan
Put up an e-mail address and i can send you a paper on setting up the current level to see if the board is working properly. The z-axis and theta-axis are swappable.....you just need to change the dip switch settings.
Electronics Forum | Tue May 07 12:30:30 EDT 2013 | shankar2013
We are having a problem with our Mydata TP9-2U where the machine shuts down during a job with this message seen on the service monitor -- F-MOT1-26/156:MOVFI: MOTOR TIMEOUT Has anybody seen this problem?
Electronics Forum | Tue May 07 13:41:36 EDT 2013 | cyber_wolf
MOVFI is a theta error there are about 10 things that can cause it. Start with making sure you do not have an acceleration set to lowest while the others are at high or highest in the package data. Next look at ribbon cables...
Electronics Forum | Tue May 07 14:33:57 EDT 2013 | cyber_wolf
The "lowest" acceleration is probably causing your problem. Switch it to the next fastest setting and see what happens
Electronics Forum | Thu May 09 15:33:01 EDT 2013 | shankar2013
No luck yet. Also cannot buy a Cent electrode motor from manufacturer. Anybody know of sources where we can buy spares for TP-9. Thanks
Electronics Forum | Wed May 29 10:05:59 EDT 2013 | Adrian
Hi , we have one unit of mydata TP9 we want to sell as spare parts machines. Selling as its condition. No feeders. If keen, pls contact me . thanks