Electronics Forum | Thu Nov 14 17:22:47 EST 2013 | dman97
Yes CP4 with vision type 12 will place these no problem. I am even putting these down on an old CP3 with no problems.
Electronics Forum | Fri Nov 15 09:59:42 EST 2013 | zrunkle_api
When I used the 12 code I saw worse placement then with the 254 that I used in the past. So far my best and most consistent results came for the GSM with only looking at the outside edges of the part. Thanks again for everyone’s help.
Electronics Forum | Mon Nov 11 08:04:54 EST 2013 | aj
hi all, I need to access the service area on my reflow oven - Vitronics SMR500.. I have tried 2 , 3,4 but no luck. Anyone know the password - am in the process of contacting Vitronics themselves aswell.. aj
Electronics Forum | Mon Nov 11 14:20:25 EST 2013 | TM
Hi All I want to know if any of you have any inputs (good/bad) from the following AOI machines, I have no experience on any of these machines, so I want to know what is the general perception of them. Koh Young, Saki, Yamaha, Parmi.
Electronics Forum | Mon Nov 11 15:58:26 EST 2013 | hegemon
We use Koh Young for Solder Paste Inspection. Has been in steady use for over 5 years. Reliable and effective. Would buy the machine again. I receive no benefit from any company listed above. 'hege
Electronics Forum | Mon Nov 11 16:03:22 EST 2013 | TM
Thanks for the info I have some experience with the Koh Young SPI, Also think very good machines, but no feedback from any AOI machine user. Does any of you have an Koh Young AOI? Thanks TM
Electronics Forum | Thu Nov 14 12:51:21 EST 2013 | emeto
From what I saw these are more oriented to SPI inspection companies. Saki looks interesting asd well as Koh Young. Why don't you consider other more popular brands?
Electronics Forum | Fri Nov 15 05:20:57 EST 2013 | benreben
Yeah saki is very good,is not a moving camera,is a scaner that scan the all board in few seconds. the programation is not the more easy,but the software and algorithm is very complete.
Electronics Forum | Tue Nov 12 09:03:29 EST 2013 | emeto
Just visually inspect the squeegee everyday. If there is some damage you will notice right away ....and yes you will start to get bad prints.
Electronics Forum | Tue Nov 12 10:44:22 EST 2013 | aaronpavone
I have previously done a masking fixture through Pentagon, but was unsuccessful I think more due to the design of the board. Does anyone else have experience with other vendors that I could try out? I have seen InsulFAB and Ascentec as well. Thanks.
