Electronics Forum | Wed Aug 12 14:06:25 EDT 2015 | bnorton
We tried restoring the Machine Configuration, Mapping, and Calibration data from after the calibration done last year. The error was still present after the restore and restart.
Electronics Forum | Wed Aug 12 17:41:15 EDT 2015 | edwaterfall01
Sorry for all the typos in the last message. As the machine was powered OFF for two weeks I would have expected a battery problem. Can you capture a Logicimm file and see what the file says before the heart beat messages?
Electronics Forum | Sat Oct 03 15:51:06 EDT 2015 | amrsalama
I have the same problem and while using logicomm it gives an error message (FC107F24) !!! how can I read this error to address the problem ???
Electronics Forum | Tue Oct 06 20:18:27 EDT 2015 | edwaterfall01
With the address of FC107F24 I would look at the Slot 11 UIMC board. Try swapping with another Radisys Board. Check jumpers, changing one jumper only on each board.
Electronics Forum | Fri Oct 09 04:51:49 EDT 2015 | amrsalama
Thanks NRS, yes UIMC by mistake was in incorrect slot (11) once we moved it to slot 12 it works, thanks again.
Electronics Forum | Wed Aug 05 18:36:19 EDT 2015 | caurbach
John, I assume you mean 60%, not 65%. J-STD-033 has a derating table for floor life which accounts for conditions other than 30C/60% RH. Table 7-1 is what you're looking for I believe. Adam
Electronics Forum | Thu Aug 06 16:34:15 EDT 2015 | capse
Yxlon, FeinFocus brand, I do Rep them in the southeastern US. www dot Yxlon dot com
Electronics Forum | Tue Aug 11 18:28:38 EDT 2015 | r92024
Thanks, Rob... when it says on that eBay mechanism that it's "adjustable," it's the length... it's scored in increments, to snap off at the required length. So no help with this issue, unfortunately.
Electronics Forum | Thu Aug 06 23:47:14 EDT 2015 | anilwagh
I have Orbotech AOI Trion2340EXP. Machine hard disk damaged and we are loaded machine software on hard disk. Need to communicate system file like config.sys and others. Please any one suggest.
Electronics Forum | Sat Aug 22 12:38:15 EDT 2015 | mdibertf
Do you still have the HD problem? depending on the cameras you have this matvary abit but try this line and make sure you have the path shown and with drivers DEVICE=D:AOIMCINTCAMINT.SYS /PCI /CD:AOIMCINTC768X484.TXT /6 regards Marcos D