Electronics Forum | Wed Apr 26 11:58:32 EDT 2017 | bobpan
Mod code 7 is a placement delay.....changing it will slow your entire program down. If you just want to slow it down for 1 placement.....you have to insert a mod code change in the sequence steps....this is easily done in central controller. Good L
Electronics Forum | Wed Jun 07 04:44:23 EDT 2017 | dentata911
Thank you for your answer. But maximum value for modcode 7 is 255. 255x3.3 msec is 0.8 sec. And I need 2-3 seconds...
Electronics Forum | Thu Apr 27 05:48:32 EDT 2017 | pavel_murtishev
jin, The answer is no. DOS has to be installed from distributive normally supplied with machine. Hopefully, machine data has not been erased. If it has been erased, than machine will have to be recalibrated. Regards, Pavel
Electronics Forum | Fri Dec 15 08:32:13 EST 2017 | robertorocco
Hi Pavel it is possible to clone the hard disk topaz machine to replace it in the future crashed? how should I do to save the calibration data of the machine?
Electronics Forum | Fri Dec 22 05:24:23 EST 2017 | protokos
Hi ii is possible to clone a hard disk, but the calibration data must be backup first. if this not can, then the machine must be calibrated.
Electronics Forum | Tue Jan 09 08:53:48 EST 2018 | pavel_murtishev
Jin, Cloning is possible, but the machine will have to be recalibrated since calibration data from running machine will be copied to failed one. As to back ups. Are you able to get into engineering menu? Regards
Electronics Forum | Wed Apr 26 22:59:46 EDT 2017 | navworx
Great posting. We're looking at AOI for the first time and are trying to understand the pros/cons of 2D, 2D+, and 3D. M, can you discuss what size parts are too small for the Mirtec MV-3L?
Electronics Forum | Sat Apr 29 08:51:39 EDT 2017 | pavel_murtishev
Evtimov, The solution you have described is called multiwave. Consider manufacturing fixture of low thermal mass composite materials. This might help. Regards, Pavel
Electronics Forum | Mon May 01 10:55:21 EDT 2017 | tombstonesmt
This has already been done. Companies like Seho Selective Solder machines can provide this service. I imagine it is not cheap. I'd be curious to compare the drop rate of parts per person per hour on a couple of Pillarhouse Jades vs on custom machine.
Electronics Forum | Mon May 01 12:22:09 EDT 2017 | emeto
Pavel, that sounds interesting. Do you know anybody working with this kind of material? I don't even know what the material will be called.