Electronics Forum | Thu Dec 08 12:06:29 EST 2005 | derengmao
Thank you for the info. I changed the "Light Cntl = 2" into "=1", the system tells "Vision not Init" but the machine works. If change to "= 0" then system tells more problem, and does not work. Do you have better idea about it? For feeder for 040
Electronics Forum | Thu Dec 08 13:05:51 EST 2005 | bobpan
In the scp.ini file you either check light control on or off.....i am not sure where you are putting numbers in at. You can use a slim feeder if it will fit onto your feederbase and if you do....you wont need the 2mm option turned on. What version o
Electronics Forum | Wed Dec 14 15:49:30 EST 2005 | derengmao
I did calibration for the fixed camera according to the Training Center System's book. But it seemed it is for diciding the heads'offset, very few is for camera itself. When calibrate, It does recognize the calibration tool ad finish. However when te
Electronics Forum | Fri Dec 16 12:50:34 EST 2005 | derengmao
I do have all tools for calibrate. The 4" plate is looked like for down-look camera. The big nozzle is for up-look camera. I did all the procedure in the handbook from Traning Center System from Quad. The up-look camera does see the nozzle, and passe
Electronics Forum | Mon Oct 24 16:10:07 EDT 2005 | Brian Davis, Compex Technologies
Dear Colleagues, We are looking at entry level AOI solutions. We are currently evaluating the Mirtec AOI MV-2HTL. We are also looking at Vitech because of their perceived "edge" in the industry. I know that this forum has approached this question be
Electronics Forum | Mon Jul 17 13:36:55 EDT 2006 | kjeffries
I appreciate your comments regarding the programmability of the Mirtec. What type of SMT machine do you use? How easy have you found it to transfer the SMT profiles to the Mirtec? How do you rate the Mirtec in handling top/bottom, multi-panel asse
Electronics Forum | Tue Jul 18 00:47:42 EDT 2006 | sant
Hi Few weeks back for the similar thread I was enquiring about the performance of benchtop AOI. I did see the Saki m/c.It seems to be a good m/c with different technology. I have not bought yet. Looking to have more feedback. Any opinion about Saki
Electronics Forum | Tue Oct 25 22:50:16 EDT 2005 | KEN
What is the (initial position) ratio of pulse counts to home encoder pulse (relative to the home sensor). It should be 50% +/- 15% Run this test several times in between a warm up. I bet your numbers are all over the place. I bet you have a loos
Electronics Forum | Wed Oct 26 03:43:11 EDT 2005 | meritajs
Hi Ken, Thank for your advice We suppose that with home position all is OK and ratio is in interval 40-60%.Y axis offset is not constant 5mm or 10mm but change ratio with working time and may be more than 10mm We think that problem is with Yservo mo
Electronics Forum | Wed Oct 26 21:44:42 EDT 2005 | KEN
If your sure your drive lines are staying put then it must be the motor. ... odd no servo feedback alarms though. That's why I thought problem might be mechanical. Does the yv84 use servo's? IF yes, then no brushes to wrory about. Don't bother t
