Electronics Forum | Wed Nov 14 09:19:45 EST 2012 | davef
Sent: Wed, 14 Nov 2012 08:23:03 -0500 Subject: RE: SMTnet Forum: Question About Blackstone Stencil Cleaner, CH-2408 Dave, This E mail is to confirm that the Stencil Cleaner Model CH-2408, manufactured by Blackstone-NEY Ultrasonics, does not require
Electronics Forum | Tue Nov 13 22:40:02 EST 2012 | davef
I expect that suppliers can just about always hold solder mask registration within a true position of 3 thou. That's the old SMT padstack think ... make the solder mask openings extend 3 thou larger than the copper. That way, even if the copper and t
Electronics Forum | Tue Nov 13 11:41:23 EST 2012 | dontfeedphils
I can't remember what motor control cards in the machine are interchangeable, but if the controller card for the theta axis is a common control card then you can swap out the one currently controlling the theta axis with a different axis and see if t
Electronics Forum | Thu Nov 15 23:45:53 EST 2012 | jaimebc
robgd3, The Z motor can be purchased separately, however, the theta motor can't. You need to buy the whole midas head. I didn't get as far as dissembling the theta motor casing to get to the theta motor. That was my worse case scenario. We ran thou
Electronics Forum | Tue Nov 20 15:03:37 EST 2012 | jaimebc
Bruce, Since we had spares, I replaced the X wagon cables, XFMB cable, nothing. FFX Cable, nothing. Swapped mot cards, nothing. Vaccum seal, nothing.At this point I truly believe the problem is either on the theta encoder or the theta motor. Unfortu
Electronics Forum | Fri Nov 16 15:55:40 EST 2012 | pctech
I am desperately in need of 200 Maxim chip " DS 2710G+ " , contacted manufacturer about this chip and learned that they will not be available untill April.I have to finish a customers order by the end of January.Is there any one out there that they s
Electronics Forum | Thu Nov 22 12:04:00 EST 2012 | rgduval
According to the look-up on the ESB, PRB Logics reports 1284 stock. As always when using brokers, there's likely to be an inflated cost, and a potential for counterfeits. http://www.sourceesb.com/ProdSearch.asp?regid=0&search=DS2710G+&sname=PNS&typ
Electronics Forum | Tue Nov 20 11:57:25 EST 2012 | torch
has anyone ever tried running these devices through a reflow process soldering the tab to the pcb then soldering the TH connections? we have a device which needs fitted but we are soo tight for space that we cannot use a conventional screw/nut to hol
Electronics Forum | Mon Nov 26 13:07:16 EST 2012 | rway
Running in series is best for less change-over, depending on how many components you use. But, as Dave stated, if you have the capacity on your machines to run your product on one machine, then you can do that and get twice the throughput. Series wi
Electronics Forum | Wed Nov 28 16:30:31 EST 2012 | rgduval
We've just acquired a batch washer at an auction, and want to install it as a closed loop system. The only problem is I have no idea where to turn or what to look for for a drain filtering system that will allow us to make it a closed loop system.