Electronics Forum | Sat Jan 19 22:42:16 EST 2013 | ngineer
Ok, I managed to figure it out, and this is simply for anyyone having this issue. The issue was that the selected board or board folder did not reside in the selected board directory. the answer was to hold LSHIFT at startup to skip the autoexec of
Electronics Forum | Mon Jan 21 09:29:33 EST 2013 | cnotebaert
I agree, you will likely need a carrier being that thin. without seeing the trace layout I’m not sure about relieving the carrier to accommodate them. if evenly distributed you shouldn’t to go that far. Are parts on both sides of the board? Don’t mak
Electronics Forum | Mon Jan 21 12:43:13 EST 2013 | emeto
A good fixture is the key here. The first side should be easier than te second(if double sided). In both cases I will try to level the top of the board with the top of the fixture. Try to lock with pins comming from the fixture to the PCB holes. This
Electronics Forum | Thu Jan 24 08:35:49 EST 2013 | ercdave1
Thank you very much for the information. I will look into the companies you listed. i hope i find one that doesnt require a lot to keep going. I am very concern on providing my equipment preventive maintenance and i hope that once i find a machine t
Electronics Forum | Mon Feb 04 09:15:30 EST 2013 | caerleon
You also could look at Europlacer's dependent on your types of products and if you need a quick changeover between products. We have 7 of these 4 Finesse and 3 EP600's - Easy to program, rarely break down and for the price have very good accurate pl
Electronics Forum | Wed Feb 06 06:58:28 EST 2013 | cyber_wolf
I have been in this business for over 20 years and have dealt with used equip sales during that time. Never heard of PFI. Not saying anything bad....just saying never heard of them. I would ask PFI for a reference list of contacts they have sold use
Electronics Forum | Fri Feb 08 11:40:57 EST 2013 | ceexchange
If you are looking for a more updated machine we can sell GSM's upgraded with windows, 42v interface, and precision pro feeder banks. Our machines will be calibrated and you will not be invoiced until after acceptance. Gregg Bartosz, gbartosz@ce-ex
Electronics Forum | Wed Jan 30 12:04:28 EST 2013 | caerleon
We have a device that uses the same technology of Li-Ion battery. We had a problem with charging and over charge part of the circuit. The issue was that the battery and the charger had the same inbuilt safety circuit to protect it from overcharge and
Electronics Forum | Fri Jan 25 13:41:04 EST 2013 | dontfeedphils
You definitely have to be careful with unsealed components and markings/labels. The best you can do is check with datasheets or find an extra assembly to test it out on first. You can also try slowing down your inline to more like 1-2 ft/min and se
Electronics Forum | Fri Jan 25 15:51:26 EST 2013 | johng
Water soluble process, yes. The machine is old and fixed at 4 ft/min by someone way before me. Looking into ways to reverse that to allow for adjusting the conveyor. Trying to determine how the contamination gets onto the boards. So far testing has i
.gif)
