Electronics Forum | Sun Jul 05 23:30:01 EDT 2009 | jeffr
A feedback error means that a particular axis did not respond by moving in a normal manner. Check the following:- 1/.. Mechanical binding. (Servo Off, then check axis moves without binding). 2/.. Check encoder plugs of that axis. Note that Philips/Ya
Electronics Forum | Mon Jul 06 01:27:06 EDT 2009 | mpolak
Hi Everyone, I am having some problems with pasting. When I print a board i expect the paste deposit to be brick shaped. Nice and square. The porblem is it higher on one side then on the other. And you can tell which direction squeegees were going b
Electronics Forum | Mon Jul 06 06:51:50 EDT 2009 | leemeyer
Many years ago we purchased a IOmega ZIP drive that would connect to the parallel port of the computer. They have a utility called "guest" that we installed on all of the IVC computers. We were then able to connect the drive to the parallel port and
Electronics Forum | Tue Jul 07 07:08:23 EDT 2009 | daxman
During a service call, We had a FUJI guru tell us that Biral was actually not a great lubricant for LM rails or rust prevention because it thickens and gums up quite quickly, which is true. His recommendation was to use TFL-50 wet lube. We've been u
Electronics Forum | Tue Jul 07 12:11:32 EDT 2009 | naynayno
We are in the process of transitioning from OA flux to No-Clean. Because of the tighter process window there is a lot of concern about component and PCB solderability and storage. The last thing we want to do is put some solderability specification
Electronics Forum | Tue Jul 07 15:02:48 EDT 2009 | snsmt
Hello everyone, I have a question regarding rework. How do you guys rework QFPs (lead free)? The only method that we are currently doing is using a heat gun. We are heating up the bottom of the PCB (approx. 2") away from the bottom of the
Electronics Forum | Thu Jul 09 12:47:09 EDT 2009 | janz
Hello, We are using F4G software for our Fuji machines. We've 5 machines plug into PC. Recently we tried to connect PC to local network but this only after while close C/C server without possibility to reopen C/C server. Reseting PC gives C/C lice
Electronics Forum | Fri Jul 10 06:20:35 EDT 2009 | kpm135
I have a stencil, on which the fids are no longer black enough for my screen printer to find them. A long time ago at a previous place of employment we had a loctite product to fill these in as a permanent solution. I have since forgotten the part nu
Electronics Forum | Sun Jul 12 21:07:07 EDT 2009 | padawanlinuxero
I have a problem we change a product from leaded to lead free, I was not involve in the selection of the new reed switch, but now we are having problems with the hermeticity in the switch,this occurs after is overmould and put to a 6 cycles in the th
Electronics Forum | Mon Jul 13 05:54:39 EDT 2009 | rway
Hello all, We are looking to purchase another AOI system with side angle cameras. Currently we are using a YesTech M1 system that has only a top-down camera (it can't be upgraded with side cameras). Does anyone have experience with YesTech F1 sys
