Electronics Forum | Fri Dec 03 04:11:47 EST 2010 | grahamcooper22
A baking oven over 100 C will be at zero humidity. Do you really need to store pcbs/devices at 200 C...this will surely harm some products ? IPC 33B01 allows storage of MSDs in a dry cabinet at less then 5%.....these can operate at room temp or 40 /
Electronics Forum | Tue Dec 07 07:26:50 EST 2010 | grahamcooper22
In an oven over 100 C any moisture will escape through vents. There will not be huge volumes of moisture in the oven when you are baking components so it should easily escape through vents / holes in the system leaving you with a humidity of near zer
Electronics Forum | Tue Nov 30 13:58:57 EST 2010 | flipit
Reading some spec sheets and am seeing profiles for reflow and TTW soldering. A Google search tells me that TTW means "through the wave". Am seeing this acronym on LEDs mostly. I have never seen this acronym before. Why not just wave or reflow so
Electronics Forum | Tue Nov 30 18:02:45 EST 2010 | flipit
62/36/2 is used often in thickfilm hybrid circuits where Pd/Ag conductors are used. The idea is that you saturate the joint with the 2% silver and thus help eliminate the leaching of the silver from the hybrid circuit pads or the component. We mix
Electronics Forum | Mon Dec 06 11:33:30 EST 2010 | gantry
It has been a while but I think the Mk2 was an upgraded ballscrew. I am a fan of the Quad products but if you are looking to bring production in house using these machines to do it, I would be very very careful and really consider new machines with
Electronics Forum | Tue Dec 07 04:23:27 EST 2010 | Jacki
Dear All I hope I can get some advice of PCB experts in here.My problem is - after wave, our big board, 640x420x1.7mm, had a warpage when the board was cooled down after wave. PCB was flat while being warm.I had tried with many type of pallet and mad
Electronics Forum | Sat Dec 18 08:23:33 EST 2010 | remullis
I experienced warpage on a 7'x 13" long board, unfortunately my oven does not have center support. I use stiffeners on both of the short ends. It fixed my problem. Some of the things I was experiencing with the warpage on the second pass were placem
Electronics Forum | Sun Dec 19 23:22:11 EST 2010 | Jacki
Hi Rem Woo, ur board is such long one,7'. Our PCB is only 2' long but 3.5kg weight b4 solder. We use wave machine to solder it and PCB was sit on the pallet. all PCB side lengths are pressed by clamps. PCB was flat just after wave, however there was
Electronics Forum | Wed Dec 08 10:20:16 EST 2010 | kevslatvin
Not familiar with your machines, but on out Assembleon Opals we take the used cover tape from another feeder and tape it to the cover tape of our cut tape we are loading with some thin double stick tape. The 3m VHB type. Then we wrap that with a piec
Electronics Forum | Wed Dec 08 09:53:23 EST 2010 | fönsi
Hello Because of the cold weather, we had some troubles with drying out of printed solder paste on the pcb's. The relative humidity in the air declined below of 20%. We have a process window of store the printed board for maximum 24 hours, but with
