Electronics Forum | Thu Mar 27 08:23:37 EDT 2014 | emeto
Hello, we have several generation of Siemens machines and one of our lines is ASM SX1 series. Machine is very accurate and reliable as a hardware, but in my opinion the software is their biggest advantage. Software is very powerful and can do things
Electronics Forum | Mon Mar 31 14:52:02 EDT 2014 | jax
Both Manufacturers and Machine Types are a good choice... Why just these two Manufacturers? Depending on your needs (Changeover times, Board Size, Part Size, Part Counts, Odd Form requirements, CPH requirements, and the list goes on), there might be
Electronics Forum | Thu Mar 27 18:07:02 EDT 2014 | hegemon
If you are 100% sure that the solder has reflowed (time and temp based), then just use an wood stick to wedge the part upwards. It just takes a little bit of "lift". I used a wooden Q-Tip end that I trimmed to a wedge using an exacto blade. Wait f
Electronics Forum | Mon Sep 28 09:23:03 EDT 2015 | slave2anubis
Hi, sorry for reopening a old thread, but i wanted to ask if there is a way to know at what temperature the solder melts if you have a chip with underfill? I thnk its lower then normal air-fill temperature since the underfill conducts heat better the
Electronics Forum | Mon Sep 28 13:03:43 EDT 2015 | dyoungquist
The melting point of the solder itself does not change when you have underfill. If the underfill conducts heat better than air, it will take less heat (and/or less time) from your rework station to get the solder up to the melting point. That makes
Electronics Forum | Sun Mar 30 02:01:46 EDT 2014 | alexeis
Hi, Our customers have SIPLACE SX1, IPulse and Samsung that are used for same needs as yours. Also, they have a software tools from us that decrease a time for SMT setup preparation as new (QPlan/QPlace) or as update of ECN/ECO (QPlace UPD). You ca
Electronics Forum | Tue Apr 01 16:14:37 EDT 2014 | emeto
Hello, I have newer generation machine(MV-7) and in my software I can open two programs at the same time. After you do that there is a button in the software saying T/B. when you press this button it will run board1(or top side) and right after you
Electronics Forum | Wed Apr 02 19:28:06 EDT 2014 | rboguski
We have had a Dage XD7600NT Ruby for about two years. We were one of the first in North America to purchase it with the X-Plane Technology. We concur with the previous post that it is primarily a manual system. Dage offers step-and-repeat features
Electronics Forum | Fri Apr 04 15:39:27 EDT 2014 | davef
I’m not going to do your job for you. Here are some links to get you started: * http://www.fda.gov/ICECI/Inspections/InspectionGuides/InspectionTechnicalGuides/ucm081273.htm * http://www.instructables.com/answers/how-to-identify-the-leakage-of-elect
Electronics Forum | Fri Apr 04 18:16:43 EDT 2014 | garym4569
We are in the process of launching a new product and found reflow solder issue with one of the inductors. I have set oven profile to paste specifications. I just finished profiling with thermocouple under problem component. All other components ex