Electronics Forum | Fri Jul 06 04:55:59 EDT 2012 | ccgooi
I have fabricated a artwork of stencil on a mylar and make comparison on PCB and Stencil in order to confirm if there is any PCB stretching at both end. The results are comparable for both stencil and PCB without any stretching . So,I assumed that th
Electronics Forum | Wed Jul 04 11:55:23 EDT 2012 | tony_d
We are a low to mid range manufacturer as well. I looked at several different vendors incuding; Mirtec, Viscom, Marantz, Omron, VI Tech, Orbotech and Yestech. We selected Mirtec. As a mid range manufacturer, one of my main concerns was quick and eas
Electronics Forum | Thu Jun 21 16:30:47 EDT 2012 | grauen06
We are currently using an ACE K.I.S.S. 104. We used SN100 solder with AIM NC265 flux (no clean, alcohol-based). Also, we use topside preheat at 100 degrees C and a 6mm nozzle (as big as we can go with this application). The PCB has a matte finish as
Electronics Forum | Fri Jun 22 21:07:08 EDT 2012 | tank1266
I have had Selective issues such as yours on two very different Selective Solder Machines. I was able to eliminate these issues by using Alpha EF-9301 wave flux with any SAC305 solder. It's a more aggressive flux, but really made the difference. Anot
Electronics Forum | Wed Jul 04 10:17:18 EDT 2012 | daxman
Good morning, Just a few questions to clarify: 1. You backed up your machine proper data. 2. You upgraded Fuji Flexa. 3. You re-transmitted the proper data 4. Now, components are not placing properly? Do you have a fuji 96-001 calibration board? Ha
Electronics Forum | Mon Jun 25 03:52:24 EDT 2012 | awtm
Our Customer had detected tarnished pad on ImAg PCBA and had conducted several SEM-EDX test at the soldermask below some of the chip resistors. High concentration of sulfur was found and it can be significantly reduced after further chemical cleaned
Electronics Forum | Mon Jun 25 11:33:20 EDT 2012 | davef
The immersion silver is an active surface and readily combines with sulfur from the environment. Silver sulfide tarnishes the surface and creates doubt about the integrity of the finish at inspection. [uyemura.com/library-4.htm] Your customer's boar
Electronics Forum | Thu Jun 28 17:05:46 EDT 2012 | davef
Here’s what we seem to know: * There’s a problem with voiding in the solder connections of SMT capacitors * A void is an open area caused by air or process fluid that is trapped within a solder connection * Voids are an allowable condition as long as
Electronics Forum | Thu Jun 28 15:22:59 EDT 2012 | spitkis2
Would like to ask end users or those with experience using infra red rework equipment (specifically when the top heater is IR) the following: 1. Can you successfully rework Package On Package (PoP) type devices? With heat directed through the packa
Electronics Forum | Fri Jun 29 10:56:56 EDT 2012 | jorge_quijano
Hi guys, I need your advise on this, I have a very uncommon PCB design (at least for me, I've never seen anything like this...) it is 32" x 18" x 0.062" and has 9 QFNs that are driving me crazy, I'm not able to get a good alignment, I can get a mediu