Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Wed May 01 15:27:22 EDT 2013 | lheiss
Hi All, I've been using a IVc for many years. I'm to the point where I have Mod Code 8 = 15, MC9 = 500, and all Extents PU delays set to 40ish. These settings work pretty well but I would like to get them closer to factory defaults to save the los
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Tue May 07 14:57:40 EDT 2013 | davef
Tape & Reel, Reel suppliers: * Advantek advantek.com/products/packaging-reels.php * Peak International peakinternational.com/tape.html * Acrotech Southwest, Inc. - Kerville, TX; (830)896-6464, Fax: (830)896-8245, SBorroum@ktc.com acrotechplastics.com
Electronics Forum | Tue May 07 14:47:31 EDT 2013 | ngineer
Z axis seems to move as it should, the flag that goes through the C shaped sensor is not broken. I have gotten it to stay on everytime i start it up now (I did NOT change anything, just unplugged it for awhile, then plugged it back in an flipped the
Electronics Forum | Tue May 07 10:14:00 EDT 2013 | tanderson
I'm trying to minimize the loss of parts due to dropped parts. Part of the problem might be I'm filling in until we replace the SMT supervisor/manager. Some dopped parts are expected and are so inexpensive it's not worth fussing over. Sometimes I fee
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Mon May 13 11:20:06 EDT 2013 | emeto
From what I have read about the topic, recommendation is to use flux for fine pitch BGAs. Printing is difficult because of the small pads. HEre is the moment where you have to make your calculations. Do you have enough assemblies that will use
Electronics Forum | Wed May 15 15:58:11 EDT 2013 | rgduval
Let me see if I understand you correctly. You have a batch washer (looks like a dishwasher). There is a top and bottom spray fixture, which would normally spray water up at the board and down at the board being washed. When you place boards in t