Electronics Forum | Sat Dec 03 01:07:29 EST 2022 | poly
I've got access to the universal manuals / voyager but I haven't found a section that describes the feeder teach setup process, I can pick up the teach slug onto the conveyor and then get into feeder teach but if I teach the corners of the slug as t
Electronics Forum | Mon Dec 05 17:46:10 EST 2022 | SMTA-64387381
Does anyone have experience with routing through areas of PCBs with Cu traces running through them. Trying concept to design in functional "wing" portions to our main board in an effort to get 2 in 1 functional boards - a fully functional main PCB
Electronics Forum | Wed Dec 07 18:16:27 EST 2022 | skolev
Hi everyone. I have little problem finding the right SMT nozzle for my new custom machine . For manipulating custom component with dimensions close to passive element 0402 . Now in machine i've put a siemens SMT Nozzle . But there are some problems
Electronics Forum | Thu Dec 08 20:04:01 EST 2022 | madmungrel
Hi there Siemens Valor Proceed Preparation is a alternative that I would say ticks your boxes as is more focused on PCBA NPI process , from Cad-Cam Data clean up SMT programming, Stencil Design, Assembly Panel Design, Test Engineering, DFA analysis
Electronics Forum | Mon Dec 26 18:02:37 EST 2022 | rgduval
So, your Hydra Z message timed out... A couple of potential causes: 1. Hydra MOT card failure 2. Hydra z-motor failure 3. Hydra z-motor encoder failure 4. Hydra z-lock failure 5. Disconnected cable 6. X-wagon cable Start by booting into service mod
Electronics Forum | Thu Jan 05 14:04:44 EST 2023 | unisoft
>> The Unisoft ProntoPLACE software ( https://www.unisoft-cim.com/pcbplace.php ) creates programs from CAD or Gerber or XY rotation and BOM files for setup of SMT Pick & Place, thru-hole, manusert & dispensing machines, and includes the basic feature
Electronics Forum | Thu Jan 12 22:29:10 EST 2023 | rgduval
So, as I understand it, IPC6012 are performance criteria that your board shop should be using. I think you'd want to be using IPC600 for acceptance criteria at incoming inspection. At least, that's what I always did in my CM days. And, since you'r
Electronics Forum | Fri Jan 13 12:36:48 EST 2023 | servin6154
There are a couple of things you can try that seemed to help me with this problem. 1.Get your HMS height off of the paper tape halfway between the pocket and the edge of the tape. 2. Change your "pick stroke" for that part to "0" 3. Check you compon
Electronics Forum | Mon Jan 16 17:07:19 EST 2023 | demradarmfg
OP here Everything you have said makes sense. However, sanity check me on this. The one thing that IPC-A-600 does not discussion is inspection sampling or frequency, which is discussed in section 4 of IPC-6012. Table 4-3 lists all these different
Electronics Forum | Tue Jan 24 13:02:55 EST 2023 | elpos
Hello everyone ! I would like to ask for some help regarding the component aligner on the Samsung CP20CV machine (I just bought the machine and I am still learning to use it). I noticed that sometimes when I instruct the Head1 to pick up (any) nozz