Electronics Forum | Thu Jun 17 17:26:56 EDT 1999 | wayne sanita
first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads. any
Electronics Forum | Thu Jun 24 14:14:25 EDT 1999 | Chris
| Does anyone have experience with placing heat sinks on BGAs? I have limited experience with PSA (pressure sensitive adhesives)heat sinks, and am interested with the possibility of a clip-on device. I am specifically concerned with ease of assembl
Electronics Forum | Mon Jun 14 15:29:49 EDT 1999 | Sergio Luiz Vito
I am looking for more information about: 1) What kind of evaluation can I do to measure the resistance to fall off of a bottom side glueded SMT component?; 2) There is some influence of doble wave solder machine (temperature, flux, etc) in SMDs fal
Electronics Forum | Fri Jun 18 19:41:24 EDT 1999 | KEVIN SIMPSON
| How are you inspecting pcbs post-reflow, are you inspecting all or sampling. The type of assembly involved would be mainly chip components with a mix of actives and a few 25mil and under pitch. | If you sample what are your fault rates looking lik
Electronics Forum | Thu Jun 10 17:10:52 EDT 1999 | mike weekes
| Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like point-
Electronics Forum | Wed May 19 22:22:42 EDT 1999 | Mike Konrad
Check out one of SMTnet's sponsers: http://www.emsr.com/hotjobs.htm Hope this helps Mike Konrad | Hello everbody! | | I was wondering if any of you have any GOOD recomendations of WEB sites to post one's resume? I've sent my resume here of cours
Electronics Forum | Thu May 20 07:34:05 EDT 1999 | Wayne Bracy
| Hello everbody! | | I was wondering if any of you have any GOOD recomendations of WEB sites to post one's resume? I've sent my resume here of course, but am looking for others as well... | | I've already been to www.monster.com, www.assemblyNet.c
Electronics Forum | Thu May 20 07:35:27 EDT 1999 | Wayne Bracy
| | Hello everbody! | | | | I was wondering if any of you have any GOOD recomendations of WEB sites to post one's resume? I've sent my resume here of course, but am looking for others as well... | | | | I've already been to www.monster.com, www.ass
Electronics Forum | Fri May 21 11:20:28 EDT 1999 | Boca
| Hello everbody! | | I was wondering if any of you have any GOOD recomendations of WEB sites to post one's resume? I've sent my resume here of course, but am looking for others as well... | | I've already been to www.monster.com, www.assemblyNet.c
Electronics Forum | Wed May 19 08:54:49 EDT 1999 | Wendy Casker
Hello, We have just received a contract to assemble some PCI daughter cards with the AMP Zpak style connectors. I am comfortable pressing connectors into backplanes, even double sided SMT, but would like any advice on designing a fixture to support
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, China
Phone: +86-138-29839112