Electronics Forum | Mon Mar 09 16:09:38 EST 1998 | Dave Celestian
Check out some of the brokers on the internet. Look under "Used PCB Assembly Equipment". "Fastex" is one of the companies that sells used equip. There are quite a few. Make sure you get a warranty with whoever you pick...
Electronics Forum | Fri Mar 20 13:08:53 EST 1998 | BILLIE CHOW
our compant have much fuji machines with low running hours.if anyone interest, email me
Electronics Forum | Sun Mar 08 06:07:18 EST 1998 | Rob F
I am looking for information on the electrical performance affects of voltage gradients in PCBs, and links or information on trends in Surface Mount Technology.
Electronics Forum | Thu Mar 05 19:21:10 EST 1998 | Jack LaRue
Does anyone know of a web page that provides troubleshooting techniques for the printing process? We aren't experiencing a problem right know but are attempting to set up a reference guide for training. Any help would be greatly appreciated. Thanks-
Electronics Forum | Thu Mar 05 13:56:48 EST 1998 | Cunli Jia
Roland, You may want to take a look at the books we carry in the SMTnet First Chapter Bookstore, particularly Understanding and Using SMT and Fine Pitch by the late Dr. Charles Hutchins. You can read the TOC and the whole first chapter and order the
Electronics Forum | Wed Mar 04 07:08:55 EST 1998 | Pat Copeland
I am looking for information on reflow temps for a flex board. There is only one 6 pin IC but the board has a 3M double sided tape. Is it possible to reflow without damaging the tape. Any suggestions?
Electronics Forum | Wed Mar 04 05:19:01 EST 1998 | Matti Maatta
Available now: HP/FourPi 3DX Model 3500G system, using cross-sectional X-ray imaging to inspect solder joints on printed circuit boards. If interested, please contact matti.maatta@fujitsu.fi
Electronics Forum | Mon Mar 02 17:31:41 EST 1998 | Nechan Naicker
I am looking to purchase a laser stencil cutting maching for use in South Africa.
Electronics Forum | Sun Mar 01 17:54:26 EST 1998 | Mike Mihld
Can anyone advise a good starting point for a temp profile for on 0.05" and 1206 component boards? These boards are simple by todays standards and do not contain any fine pitch or other special components. Thanks in advance... MM
Electronics Forum | Sun Mar 01 14:51:55 EST 1998 | Vincenzo Longobardo
From several months I am investigation about the VOIDS PERSENCE and his important as reliability. One question now is : It is possible that on the BGA components the voids are already present into the balls, before the mounting on the pcb ? If you ha
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, China
Phone: +86-138-29839112