Electronics Forum | Mon May 08 19:27:27 EDT 2006 | Tech
Does anyone know if you can teach feeder pick up location on 24mm. I have a 1998 Philips Topaz. Thanks
Electronics Forum | Tue May 09 21:56:22 EDT 2006 | KEN
Yes. Teach 24mm feeder. 1. Set pickup to "Teaching" or "relative". 2. Adjust coordinate. 3. Celebrate with high fives and chest bumps like in the beer comercials.
Electronics Forum | Thu May 11 01:30:27 EDT 2006 | pavel_murtishev
Good morning, FYI, it's better to set "relative" instead of "teaching" for tape feeders. In this case optimizer will have an opportunity to change feeder position during program optimization. "Teaching" will fix feeder position and optimizer will ne
Electronics Forum | Tue May 09 22:50:20 EDT 2006 | davef
Yoinks. We'd look dispensing solder paste. Preforms are expensive, but try for yourself. What is the 'plus' part of 'PIP plus'?
Electronics Forum | Fri May 12 08:54:05 EDT 2006 | Rob
Remember, the components' bodies are not going to like the elevated temperatures - you may want to trial a few before you expend too much effort on preforms.
Electronics Forum | Mon May 15 10:58:56 EDT 2006 | Smartasp
Thank you guys for all the info. Sure have a beter idea now. The archive was also helpfull. Have to run some tests myself. Cheers Smartasp
Electronics Forum | Tue May 09 09:10:30 EDT 2006 | Chunks
Grease filters work well. They're cheap, easy to clean and come in all sizes. Will not reduce your air flow by much either.
Electronics Forum | Tue May 09 15:02:46 EDT 2006 | Chris (2)
Hi Chris, We have only produced a few RoHS assemblies as of yet but we have not had one tombstone so far (knock on wood) I'm hoping that will not become a problem. We have enough of them now! Good Luck Chris
Electronics Forum | Wed May 10 00:46:32 EDT 2006 | Chris
I agree! I am using a SAC305 no clean from Alpha. I have noticed that even hand probing with volt meter leads requires me to press very hard on the pads to bust through the flux residue.
Electronics Forum | Wed May 10 12:22:45 EDT 2006 | reg
Hi everyone, I am trying to evaluate the cost of buying new equipment. One of the concerns is blade holders, stencil frames and board vacuum tooling. How difficult is to change from Dek to MPM or viceversa without changing all our tooling.
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, China
Phone: +86-138-29839112