Electronics Forum | Tue Jul 10 10:06:55 EDT 2001 | mzaboogie
Hello Dave, Sorry it took so long to reply. When we did our profile we did attach the thermocouples to the lead foot right above the pad. I suppose that the leads could have been hotter than the PCB pads although, other areas that were profiled were
Electronics Forum | Mon Jun 25 10:35:39 EDT 2001 | rkevin
Despite all my efforts I cannot eliminate icycling on my t/h leads. They come and go.... daily, lots of rework. I have eliminated the following from the scenrio: Inadequate flux to promote quick drainage, Pot temperature too low, Soldering surface
Electronics Forum | Mon Jun 25 11:26:36 EDT 2001 | wbu
What about conveyor speed? I tried to manage that the speed of the board and the speed of the wave were nearly the same at that point where the leads are leaving the wave. But actually I haven�t seen icycling except at one time and that was solved r
Electronics Forum | Tue Jun 26 09:37:28 EDT 2001 | Steve Vargas
We are interested in doing some further studies on our cleaning process, particularly with respect to how well we can clean underneath low profile components. As an SMT subcontractor, we'd ideally like to qualify our chemistry/cleaning process to cer
Electronics Forum | Tue Jun 26 12:39:08 EDT 2001 | danial
Our mother company shipped to us a lot of old datecode material and upon running them in the line we experienced non-wetting condition, esplly on the 0402 ( not tombstone ) We have run a dip-and-look test but I guess the method is very subjective as
Electronics Forum | Mon Jul 09 14:03:39 EDT 2001 | ohboy
Make sure you're getting a good roll from your squeegies. Poly will "scoop", leaving less, nickel will add a little extra. A slightly shorter blade height out of the holders will help promote a good roll- this helps push the paste into the thru h
Electronics Forum | Thu Jul 05 07:22:43 EDT 2001 | murray
Dear Herb Intoduce a decent light source (halogen desk lamp or similar)when aligning. Then concentrate on the refection as you adjust in the x & y rather than trying to see edges of pads as they pass the appetures. Start with rapid sweeps to get
Electronics Forum | Mon Jul 02 06:01:22 EDT 2001 | wbu
Well, I�ve never encountered any problems with it. If you use paste in the specified window according time and environment there should be no problem. If you try to measure this force you would IMO check out if you yourself did not treat the paste as
Electronics Forum | Wed Jul 04 14:22:51 EDT 2001 | davef
I just rooted through an analysis that we did five or six years ago [so current it aint] and finally found the goods. We talked to Vitronic, Heller, Electrovert, IR, and Conceptronic. Only Electrovert had a 2.75" throat [rail to top of board cleara
Electronics Forum | Thu Jul 05 06:36:14 EDT 2001 | nifhail
Thanx Dave, I agree with you on the planning part...yapp!! the same guy who've thrown an old datecode components to me..now they did it again on the PCB. Well Dave, could you explain a little bit more about the "hi-test flux" that you mentioned ab
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, China
Phone: +86-138-29839112
