Electronics Forum | Fri Oct 25 03:46:37 EDT 2002 | Adam
GUYS HOW SAFE IS IT TO USE RMA FLUX WHICH IS DESIGNED FOR WAVE SOLDERING, TO USE FOR TOUCH-UP/REWORK ? CURRENTLY ALL OUR OPERATORS HAVE LITTLE RE-FILLABLE BOTTLES AND GO AND FILL THEM UP FROM THE FLUX CONTAINERS ( I'M NOT EVEN TOO SURE WHETHER OR NO
Electronics Forum | Fri Oct 25 14:46:50 EDT 2002 | russ
Leading edge, This is used to determine the orientation of the board as you want to run it. If you use center justified stencils this is usually not an issue since you can just turn the stencil any which way you want to. If you are using front/rear
Electronics Forum | Tue Oct 29 15:55:16 EST 2002 | babe
If you are using a low end hot air system IE: Weller, Hakko or Pace then your problems are with the system and not necessarily with your process. However process is important. We have found by inspection with an Ersa Scope (BGA inspection system) tha
Electronics Forum | Wed Oct 30 12:32:10 EST 2002 | dragonslayr
Have you tried doing a reflow of the BGA with the connectors removed? This should solve the question of connector proximity giving you a problem. Also, try rotating the board 90 deg in your rework station before reflowing a BGA. Be sure to rotate th
Electronics Forum | Tue Oct 29 15:25:12 EST 2002 | russ
Thanks for the info, I have previously not used the Ps and Qs so to speak and I am finding now that we are running into trouble mostly due to component height and body sizes. So for example we currently have "16 pin SOP" what we need is "16 pin SOP,
Electronics Forum | Wed Oct 30 02:53:43 EST 2002 | Frank
The market is ripe with used equipment out there. So a small CM, such as us, are looking to find a good deal out there. I am concerned about being able to get service support from a PnP manufacturer if we buy equipment on the used market. Particul
Electronics Forum | Wed Oct 30 11:34:12 EST 2002 | Jeff Park
I purchased a used 1993 JOT stacker and when we recieved it the battery in the Omron Controller was dead so the program is lost. I have tried to get a copy of this program directly from JOT but they can not locate a copy of it as they say they have c
Electronics Forum | Thu Oct 31 10:14:53 EST 2002 | cyber_wolf
Sorry if I offend anyone, but service and maintenance contracts are extortion. You will get waaaay overcharged for something that any decent tech with experience should be able to do for you.(For a tenth of the cost) I don't care what anyone says.I
Electronics Forum | Thu Oct 31 10:25:00 EST 2002 | gregp
Contact Systems has a second (third, fourth, etc) owner support policy. There is a fee which varies for the various products. This fee includes a three day comrehensive training and entitles the user to unlimited phone support. The training is the
Electronics Forum | Thu Oct 31 11:29:34 EST 2002 | ricardof
When we buy equipment from a broker or used eq. dealer we try to support that equipment with our own skills, and this is achievable for new equipment or equipment similar to that one we're using. But when we buy older platforms or a machine with old
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, China
Phone: +86-138-29839112