Electronics Forum | Wed Apr 30 08:00:33 EDT 2003 | pjc
Jason, In Transmission AXI the entire solder joint volume is imaged, not just a slice (no missing information) as with Cross-Section. Also, there is no signal loss from mechanical or digital image reconstruction (highest contrast and edge strength).
Electronics Forum | Mon Apr 14 22:59:18 EDT 2003 | mantis
We Operate a procedure were by all potenial employes who are likely to be exposed to lead are screened for lead content in there blood prior to hiring,and once every year there after.There is no compensation given as this is mandatory but it is also
Electronics Forum | Mon May 17 15:14:12 EDT 2004 | solderpro
Agree with Joe 100%, we recently brought one in from Malcolm for trial, this company had not practiced viscosity reading or anything in the process, the trail run was a great improvement in print, consistancy, deposition and formation of the solder b
Electronics Forum | Wed Apr 23 07:46:49 EDT 2003 | pbc1963
Bernard, The problem we have is when unloading the feeder several components may be lost due to the partial peel back of he cover tape. This area I am referencing just passed the point of the knife to the pick area. Also matching the correct feeder
Electronics Forum | Fri Apr 25 17:47:23 EDT 2003 | kenBliss
Pete I can fully understand the inter-departmental problem your dealing with. A couple of simplistic thoughts since your only dealing with pennies. You cannot afford to run out or the parts you are dealing with or you will have thousands of dollar
Electronics Forum | Tue Apr 15 14:10:30 EDT 2003 | russ
here is how it is done. 1.Position the stencil in the machine. 2.Position the board onto the PCB tooling as close to being aligned with the stencil as you can. 3.Place mylar or some thin clear material over the board. your printer should have prov
Electronics Forum | Wed Apr 16 01:40:17 EDT 2003 | praveen
Hi , We are using water wash solder paste to solder the SMT LED's manufactured by Chicago Miniature lamp (CMD93-21 & 22)and Kingbright. Achieving the solder fillet , wetting has no issue but we observe high fallout at the functional testing. If we do
Electronics Forum | Wed Apr 16 08:51:10 EDT 2003 | russ
You don't need to guess at belt speed, for example if your oven (heating area) is fifteen feet long, run at 1 ft./min that will be 15min total process time. As far as temp profiling you need to run T/C because each oven is different even if it is th
Electronics Forum | Wed Apr 16 14:50:48 EDT 2003 | jonfox
sounds like a profile for some type of adhesive. depending on your required profile (manufacturer supplied) make sure that it matches it. For most adhesives (loctite, etc...) you just have to make sure it reaches a certain temp (150C for example
Electronics Forum | Wed Apr 16 10:45:16 EDT 2003 | Takfire
Recent cross-section analysis for a customer complaint revealed voiding in the solder fillet. In some cases, the remains of outgassing were also observed. During the failure analysis, we also observed failures where the solder fillet wicked on the
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, China
Phone: +86-138-29839112