Electronics Forum | Thu May 29 14:48:45 EDT 2014 | olek
On one of our designs, we use LEDs Lite-On/LTST-S110TB (SMD). PCB footprint was designed according to manufacturer's recommendations. However, our vendor has problems with assembling these parts. Some parts are tilted, other have bad solder joints or
Electronics Forum | Fri May 30 20:03:14 EDT 2014 | hegemon
Starting with the manufacturers layout is a good start. Tilted parts, bad solder joints, sounds like a wetting issue and the board or the parts. Insufficient solder sounds like the printing process needs some attention. We have used this part in th
Electronics Forum | Wed Jun 04 21:11:11 EDT 2014 | isd_jwendell
This style gave me grief as well. The problem is the way the part is manufactured leading to an unusual pad configuration. When the part is placed on the PCB there is no pad wrap under the part, the pad is 90 degrees to the board. The datasheet shows
Electronics Forum | Thu May 29 19:26:06 EDT 2014 | wesleyintelli
Hi, We have recently installed a CP40LV+. Unfortunately the machine fails to do the pre-rotation (from feeder to library) when placing parts and as a result throws an error after scanning the part. However, it works when test picking the part. We h
Electronics Forum | Sun Jun 01 03:42:49 EDT 2014 | sync40
Hello to everybody in this forum, I would like to know any information that you kindly may have about the following subject: We very often do manual soldering assembly of immersion tin finished PCBs. Since thiourea is used in the formulation of the
Electronics Forum | Sun Jun 01 13:25:26 EDT 2014 | davef
Eurolanders and Asians are the primary users of immersion tin. In the US, the use of immersion tin is restricted due to the concern over the thiourea that used in tin plating process. Thiourea is a suspected carcinogen. I’m inclined to say, “aww, as
Electronics Forum | Wed Jun 04 10:51:28 EDT 2014 | clydestrum
Well, we cannot make the cuts any deeper as then we would incur a significant amount of "bowing" at SMT placement/reflow. -Has anyone ever heard of changes in material/laminate makeup that causes this? A sort-of stronger, or more flexible tensile st
Electronics Forum | Mon Jun 09 10:03:40 EDT 2014 | clydestrum
Well, typically we put rails on a lot of the boards due to the absence of fids and/or tooling holes. We do have a fixture that is somewhat universal that I could try to introduce into the next run. Unfortunately, the next run does not help my proble
Electronics Forum | Fri Jun 13 16:23:47 EDT 2014 | esoderberg
I did not see any mention on the inner layer setback. We use 0.025" and have not had problems. Point loads with either a CAB or a FKN can sometimes be problematic. I would search out someone you know that has a fancort industries VDP5. This cuts th
Electronics Forum | Wed Jun 04 02:54:15 EDT 2014 | jasmine01
Q:Why we need to bind MAC and IP Address under a switched network ? How to set Cisco Switch on the IP-MAC Binding ? A:The binding between MAC address and IP address can avoid embezzlement of internal IP addresses. As we know IP address is very easy
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, China
Phone: +86-138-29839112