Electronics Forum | Wed Oct 23 09:41:49 EDT 2002 | Antonio
Can anyone give me a ran down process on CSP? Is it like BGA process that needs reflow? what oven do I need...vapor, nitrogen or convection? is under fill a necessity? when and why do i have to under fill? when not to underfill and why? etc.... than
Electronics Forum | Wed Oct 23 22:16:42 EDT 2002 | peterson
Hello everyone. Can someone please tell me if there are problems using No Clean solder for SMT and then using WS Flux with our Wave process? We are aquaeous cleaning after...but are there other cross-contamination issues? THANKS!!!
Electronics Forum | Fri Oct 25 04:13:33 EDT 2002 | kcngoi
Hi, No clean mean is no need to clean. Of couse if you usin incompatibility solvent to clean, the white residue will appear. If cleaning is needed, source the suitable solvent and this always suggested by your solder paste supplier. regards
Electronics Forum | Tue Oct 29 08:41:48 EST 2002 | peterpaulmary
from my experience, no clean mean "difficult and cannot clean" Normally, you will observe white residue when cleaning it. You should study the flux in the no-clean solder cream before cleaning it. Or change no clean solder to clean type solder
Electronics Forum | Thu Oct 24 03:03:13 EDT 2002 | harriss
Hi: The component height will increase on the PCB after reflow soldering. But i don't know the accurate data of the increased height. Who can help me to get it? The stencil thickness is 5 mil we used. Thanks Harriss
Electronics Forum | Thu Oct 24 13:32:03 EDT 2002 | russ
There are many factors that will affect post soldering height. Lead shape/type, pad geometry, fillet formation, etc... You will need to measure each type of component before and after reflow. Russ
Electronics Forum | Thu Oct 24 06:01:16 EDT 2002 | Kent
I'm currently dealing with an design of an end effector that need to pick n place a BGA dead bug package. The design is using peumatic system to do the task. Any advise or suggestion on this kind of design?
Electronics Forum | Wed Jun 09 02:35:10 EDT 2004 | Bernard
Base on the PORON foam rubber recommended, is it possible to apply on small BGA chip of 4x4 ball size 0.3mm. Any specific part no and supplier for this type of foam and is it a anti-static material? Would it be possible to punch out at dia. 3mm?
Electronics Forum | Fri Oct 25 04:06:56 EDT 2002 | kcngoi
Hi Adam, Excessive heat from soldering iron will left the burn mark of RMA flux. The residue is hard to remove. Suggest to use the Flux pen for better control.
Electronics Forum | Tue Nov 05 16:21:52 EST 2002 | RicardoF
Thank you Gentlemen, that info is very useful, in fact I'm on the engineering side but I just wanted to prepare a brief description of COB process and what the requirements are. Thank you again
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835