Electronics Forum | Mon Apr 16 11:28:50 EDT 2012 | vparis
Hey Reese what is your Mis rate? Do you have any boards that are passed that have actual defects?
Electronics Forum | Mon Apr 16 13:24:04 EDT 2012 | rway
That's hard to quantify. I deal with escapes when they occur, but I haven't kept track of that data. It doesn't happen to often. But when it does, I take it back to the AOI to analyze why it escaped, and change the algorithm to catch it, if I can.
Electronics Forum | Mon Apr 02 14:30:25 EDT 2012 | davef
The way you phrased the question implies that your rework uses OA. Why not do low res rework?
Electronics Forum | Mon Apr 02 15:31:20 EDT 2012 | jdumont
Hi Dave, we certainly do use low res. Still not comfortable with leaving anything behind however...Figured some brain would have a product for this. If not, this brain will have to create one and sell to other brains on this forum. :)
Electronics Forum | Fri Apr 13 10:37:04 EDT 2012 | bandjwet
We actually have a product on the dwg bd for this. Contact me off line if interested. Bob Wettermann bwet@solder.net BEST
Electronics Forum | Tue Apr 03 12:35:08 EDT 2012 | deanm
We have the same machine running the same alloy and have not seen this problem, but we're not running it nearly as much as you do. Have you asked Pillarhouse what could be happening? Try sending photos to them. They have been helpful in the past.
Electronics Forum | Tue Apr 03 13:28:11 EDT 2012 | davef
Is this related to this specific machine or this product? * Is this machine having a tough time regulating pot temperature? * Is this product dragging-out solder from the pot when it is being run so quickly? * Is this board out-gassing to create thes
Electronics Forum | Tue Apr 03 06:08:11 EDT 2012 | rpa
Hi, where can i place a manual tray feeder on OPAL XII - Assembleon. I tried to put the tray on rear side feeders positions and teached components array positions but an error occurred "software outlimits".
Electronics Forum | Tue Apr 03 08:34:38 EDT 2012 | thanh
REAR, NEXT TO TABLE UP AND DOWN. CHANGE FEEDER SET UP TO FIX TRAY. MAKE SURE YOU HAVE CORRECT NUMBER OF X,Y COMPONENTS IN TRAY AND NUMBER OF TRAY FOR THE PART.
Electronics Forum | Tue Apr 10 05:49:18 EDT 2012 | torch
these would be the guys to talk to at your end http://www.goppm.com/ depending on your machines you may want to upgrade the software side to enable a more user friendly setup environment
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835
.gif)
