Electronics Forum | Fri Jan 19 11:34:13 EST 2007 | realchunks
I thought the same thing but he did mention density. I threw out the color thing immediately - which is normal. But to NOTICE a density proble with set programs seem aby-normal. Unless one our maintenance guys got a hold of your machine for a PM.
Electronics Forum | Fri Jan 19 13:42:11 EST 2007 | russ
Even the level of solder in the pot can have effect on your wave height. backflow gate may have been tweaked a bit, that affects wave height, many many things affect the proper RPM required for the correct wave height. Pot may be a little lower tha
Electronics Forum | Tue Jan 16 07:51:19 EST 2007 | realchunks
Your Quality Manager won't let you make changes, yet you get blammed for process problems? First, you need a change in management. Second, if you can't change set pre-heat temps, change the conveyor speed. Slow it down and see if your joints loo
Electronics Forum | Mon Jan 15 15:42:45 EST 2007 | realchunks
Dback is right. You're missing part of your manual. Once you perform steps 5-7 you should get an indication that you calibrated correctly. Man, it's a cardinal sin to recal conveyors once you have programs adjusted. Why did you feel the need to
Electronics Forum | Tue Jan 16 07:51:23 EST 2007 | leemeyer
I have found a screen in the software that appears to be some setup data for the conveyor. I cannot find any information in the manual refering to this screen. If you open "SCREENS" then "DEBUG DATA" then "CONVEYOR" there are some setup parameters. D
Electronics Forum | Tue Jan 16 11:16:10 EST 2007 | jaimebc
There is another screen where you can select the sprocket size, since we have an Omniflo 7 as well, it may be worth looking into. Go to Set up/Configure/Option/Conveyor. There you will see Options for different Drive sprockets. Ours have 21/55 tooth
Electronics Forum | Mon Jan 15 15:40:18 EST 2007 | pyro747
Having problem with a 2X50 SCKT Strip PTH component(fine pitch) bridging on the wave. The PCB runs in wave pallets. Just wanting to know what successful findings have been done to eliminate bridging? Pallet angles? Copper or titanium inserts? Air kni
Electronics Forum | Tue Jan 16 20:44:07 EST 2007 | davef
Bridging Causes: Insufficient flux, Excessive pre-heat, High conveyor speed, Solder contamination Look here: * http://www.smtnet.com/library/files/upload/Reflow%20Wave%20Poster.pdf * http://smt.pennnet.com/Articles/Article_Display.cfm?Section=Archi
Electronics Forum | Tue Jan 16 01:37:09 EST 2007 | grantp
Hi, If you need to get a humidity target, the best way is to run the air conditioning plant very cold, which will drop the moisture out of the air, and then you can reheat to the required temp, and install humidifiers to re humidify the air to the r
Electronics Forum | Tue Jan 16 10:45:36 EST 2007 | PaulD
Im looking for some help I have a tp18 that will not initiate the error is f-mot1-38-245:msetdynx I tried several things. I've swapped mot cards to not avail, checked the long ribbon cable and so forth if anyone knows what this code means it would be
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835
