Electronics Forum | Fri Sep 06 03:06:18 EDT 2013 | 5pcb
We are a complex pcb supplier in China. We are good at making prototypes and multilayer (8-20)layers PCB. If you think your boards are difficult enough, you can contact me. Let's talk details. sales2@dmele.com Name:Lily Tel:0086-0755-23006293.
Electronics Forum | Sun Sep 08 18:06:30 EDT 2013 | davef
Protect the board: If solder mask protects the board, the level of protection is limited and inconsistent. If you want protection, you need the be thinking conformal coating. Selective ENIG: I believe the reason solderability protection, except mayb
Electronics Forum | Mon Sep 09 17:01:21 EDT 2013 | proteus
I wish I knew the MSL. The factory data sheet from 1995 does not list the specification. The moisture problem makes perfect sense for what I'm seeing. When we replace these parts by hand (no reflow) the failure rate goes down to almost non-exist
Electronics Forum | Mon Sep 09 15:38:02 EDT 2013 | arendonk
Hi, We are having issues aluminum wirebonding on ENEPIG plated PCB by a too low pull force and or having lifts (1% range). Could any body advice how to solve this problem? Is there a special wire bond grade required? How to best clean contaminant
Electronics Forum | Mon Sep 09 18:10:35 EDT 2013 | davef
I don't know, but here is a link to a paper from the fine SMTnet Technical Library on a similar topic: http://www.smtnet.com/library/files/upload/Wire-Bonding-and-Soldering-on-Enepig.pdf Contact the authors and ask for their advice and help. BR, d
Electronics Forum | Tue Sep 10 10:38:12 EDT 2013 | rway
Most of the PTH components are manually inserted. Some are auto-placed by our UIC machine. The parts are preped before install, so there is no need to trim the leads afterwards. The boards go through wave solder. The UIC machine has a clincher on
Electronics Forum | Wed Sep 11 10:48:02 EDT 2013 | gregp
Hi Reese, The UIC machine is (was) good for higher volumes. Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts? Also, are the UIC through hole machines still fully supported with ampl
Electronics Forum | Thu Sep 12 11:22:58 EDT 2013 | gregp
Wow, great information! I have a feeling you are talking about some predominantly through hole assemblies with mostly common components. In this case fully automated solutions make sense if the volume is there. But these machines cannot do everyth
Electronics Forum | Sun Sep 22 02:32:33 EDT 2013 | alexeis
Hi, If your PCB is large, you waste a time. Any picture, you takes, will be with corner distortion. I suggest you to: 1. use AOI (manually or automatically) 2. try simulation of your PCB production before real SMT production process 3. use human FAI
Electronics Forum | Mon Sep 16 04:24:15 EDT 2013 | JB
Thanks for the reply Larry, I've checked the springs and they look ok, I have swapped them just to make sure. What I have noticed while manually moving the head up & down, there seems to be a sticking point, I have checked the rails and they are clea
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835