Electronics Forum | Thu Oct 06 12:18:31 EDT 2016 | davef
Looks like moisture bubbling out of the board. I doubt that your baking at 60*C for a half hour is going to do very much to dewet the board. 60*C is warm to the touch, that's it!!! Water boils at 100*C. 60*C is the temperature of a cup of Dunkin. Cr
Electronics Forum | Mon Oct 17 12:18:04 EDT 2016 | intro
If I remember right you must go to secret screen . There you can change parameters of machine including language. You can find it in old posts: secret screen or panasonic password. one example for spp-g3 printer is: Request - F8 - F1 - F7 - shift - S
Electronics Forum | Tue Oct 11 14:02:59 EDT 2016 | mnorthey
We have a slider Bar on the back side of our Delta Wave. It is adjustable and slides up and down (adjusting bolt) on the back edge of the Lamda Wave to prevent this problem; keeping the trough behind the Lamda is essential as well. Along with attenti
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
Electronics Forum | Tue Nov 01 12:28:36 EDT 2016 | comatose
It depends. Are you hand breaking them, rotary knife or linear knife? Hand break you want to be about 5mm (and it isn't a great practice even then) with a rotart knife you want to keep parts probably 3mm, especially capacitors. With a linear knife we
Electronics Forum | Sat Nov 05 20:23:11 EDT 2016 | sarason
Close but not to close, would have to be the spec. Or depends on your separating technology. Prerouted boards on a panel, you could go right up to the edge. V-grove you will need more distance, maybe 2mm's or more. The distance from the panel edge to
Electronics Forum | Thu Oct 20 12:33:39 EDT 2016 | cyber_wolf
We get our fids laser etched and never have fid read problems. They are black. (see attached) All of our printers are Momentums. Half etch and fill is old school. I used to take 2 part epoxy and mix black printer toner into it and squeegee the mi
Electronics Forum | Wed Oct 12 10:18:57 EDT 2016 | chartman1
I bought a used router for a very small need and it didn't come with manuals. I have nobody with experience to run the machine. I am searching for someone that might have one of the units that could make copies of the manuals for me. I would be happy
Electronics Forum | Thu Oct 13 03:02:01 EDT 2016 | souldierann
I hope you could able to help me how come the fuse blown out when we powered up the board containing relays. The relays rated current is 80milliAmps only compared to the 2A fuse.The relay contact form is SPDT.
Electronics Forum | Thu Oct 13 11:19:01 EDT 2016 | chabscan
Hello, my fellow SMTnet users. I've been using my Quad 4C for some time now and I come to you with a question: What's the difference in the measurement of a leaded and a non leaded component, why does it have a different function for each one (FUNC
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835
