Electronics Forum | Thu May 10 05:46:29 EDT 2018 | ringelgr
Hi We are using a Sony SI-F209,yesterday we encounter strange error. The machine fails to start any servo motors and we get the message shown at the attachment. Hope someone can figure it out cause we're really stuck right now. We spoke with the com
Electronics Forum | Fri May 11 05:46:01 EDT 2018 | ringelgr
No i didn't move any cable just cleaned the old grease and applied a new one, also checked the tension of the belts and cleaned the inside of the machine. In any case no cables where moved at the maintenance process. And the only info i have is the
Electronics Forum | Tue May 22 14:35:27 EDT 2018 | designchain
Most are reaching out to suppliers and asking whether the parts/materials they are buying contain any of the Prop65 substances. Others already have that info because they've been collecting it all along. The challenge, after getting the data, is det
Electronics Forum | Mon May 14 10:57:08 EDT 2018 | Robl
Hi Ivan, We use a strong double sided tape/sheet. I would be concerned with an adhesive as it would still be curing going through the machines, gassing out vapor. The double sided works OK with our 0201 test board - 16000 placements in rows at 0,9
Electronics Forum | Tue May 15 04:15:36 EDT 2018 | godless
After reinstalling software, i get message when loading printer: "A printer file could not be opened, therefore the printer cannot be started. Please inster your calibration diskette and press confirm. or contact or contact DEK customer support. Pres
Electronics Forum | Wed May 16 08:48:14 EDT 2018 | charliedci
Looking for anyone that is familiar with Assymtek coating, 2004 model C-718, running on Windows NT. We experienced the blue screen of death (cannot find dll), had IT recover programming, install another hard drive in PC but now manual control of disp
Electronics Forum | Tue May 22 02:21:12 EDT 2018 | robl
Hi Reckless, We've had machines from all over the world off it, just need to keep an eye and move fast. Had quite a bit from USA over the years, also Korea, Scandinavia, Germany. Good deals don't tend to hang around. Rob.
Electronics Forum | Fri May 18 12:42:50 EDT 2018 | arachid
Hi, i search for drawing of calibration slug to calibrate a vu4/6 vision system on a quad 4c. on my manual it is name spindle runout calibration slug but not have part number. if you can give me this drawing i will very apreciate it. I need picture,
Electronics Forum | Tue May 22 08:23:55 EDT 2018 | dleeper
metal blades scraping against a metal foil; do it enough times and any stencil will look like that. It's possible the squeegee pressure is set too high, exacerbating the condition. Try reducing squeegee pressure a little at a time, making sure you
Electronics Forum | Thu May 31 06:25:23 EDT 2018 | cyber_wolf
Diego, In my opinion you are wasting your time testing. Set the squeegee pressure until its just cleaning the stencil off. That is the correct pressure. Unless you are getting failures at SPI (if you have SPI) or getting solder defects don't worr
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835