Electronics Forum | Thu May 05 11:11:20 EDT 2011 | jimlas53
OK, understood. In the case of SO14, I have some in vibe feeders and some in tape. The tape parts, when I set the extent up, would be picked at 0 Theta, because the part length is parallel to the Y axis. The vibe parts, which are perpendicular to
Electronics Forum | Wed May 04 06:06:34 EDT 2011 | clampron
Good Morning, I have been working with a company that has a selective electroplate touch up system from Rapid Electroplate. They have used this for repairing gold electroplate. Scratches and in some cases, replating pads that had been contaminated w
Electronics Forum | Tue May 10 15:44:24 EDT 2011 | davef
From your graph, we just don't see the the relationship between failures and relative humidity. Questions are: * What is the correlation between failures and RH? [We'd bet that the correlation between failures/RH and failures/temperature are 'similar
Electronics Forum | Tue May 10 15:57:43 EDT 2011 | jamike
Hi I am responsible for the whole of production and test and have been given the job by my manager to get accurate job times on all assemblies timing various staff. I have 18 years experience working in all areas of production and test so I know the
Electronics Forum | Tue May 10 20:38:04 EDT 2011 | wolverine
I am going to have to install new timing belts in a Samsung CP40 series machine, these are the belts that run on each side of the placement head gantry. Do not have technical support from Samsung nor do I have a service manual for the machine, just t
Electronics Forum | Thu May 12 08:29:54 EDT 2011 | don7888
Hi I am looking at reducing the time it takes for our operators to complete a first off on the first board that comes off the p+p machine. I started off by conducting some RCA to find out what was the main cause of boards failing the first off. From
Electronics Forum | Fri Jun 03 14:33:16 EDT 2011 | sunrotor
Amen... Until the process is designed, documented, employees trained and proficient, equipment maintained and calibrated, parts issues resolved, programming corrected, attitudes adjusted, and timetables reasonable, there is no need to tweak the inspe
Electronics Forum | Thu May 26 07:50:33 EDT 2011 | scottp
What process steps have been completed before the cross-section? What type of devices have solder cracks? Are the cracks found after just normal processing or after some type of validation testing? It is very unlikely to be a heating/cooling issue
Electronics Forum | Fri May 27 05:16:28 EDT 2011 | aj
Hi, There are quite a few suppliers so you could have a lot of work on your hands trying them all. Do a bit of research finding out what paste all the big guns use? they spend a fortune doing evaluations etc But you should get at least 3 different
Electronics Forum | Mon May 30 09:11:15 EDT 2011 | davef
3a ANSI/J-STD-001: * Temperature and Humidity: 18-30°C, 30-70%RH ** If out of range, shall verify electrostatic discharge control program according to ANSI/ESD S20-20 is adequate. ** For process control, more restrictive temperature and humidity lim
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835